Distributor Screw Guard
The distributor screw guard is suspended between the front conveyor screws and fits over the lower screw. This guard is for the purpose of deflecting the matrix away from the lower screw as it drops from the combination bar.
On models 1, 2, 3, 4, 5, 18, and 19, this guard is fastened by two nuts to the two machine screws projecting through the front side of the combination bar.
On models 8, 14, and 14-s-k this guard is loose, working on a fulcrum rod, and operated by the distributor screw guard lever and the right-hand locating bar. The lever is fastened to the right-hand magazine frame guide by a fulcrum screw. Whenever the locating levers are shifted for the purpose of raising or lowering the magazine frames, a screw on the right-hand locating lever moves against the guard lever and forces the guard upward. If there are any matrices on the combination bar when attempting to change the position of the magazines, this guard will strike them, and prevent the guard from making the full upward stroke. Retarding the bar prevents the locating levers and blocks from moving far enough to clear the bar stops, thus not permitting the magazine frame to be moved.
If the magazine frames were changed with matrices on the bar, these matrices would drop in the magazine that was in operating position, causing wrong fonts in the magazine.