TO FINISH THE SNUFF-BOX.
Make your box and lid of hard, well-seasoned wood; hollow them out, and polish the insides, only omitting to cut the lip upon which the lid fits, and which will be formed by the tortoise-shell. As you hollow out the box and lid, keep fitting in the shell, that you may not make them too large; when it slips in rather tight, take a point tool and cut some circles on the inside of each; (this is done to enable the glue to hold firmly.) Now, take the tortoise-shell and file that part that is to be cemented to the box, so as to make it rough. Take a pair of compasses, in one end of which is a sharp knife, set them to the exact size of the inside of the bottom and lid, then place them on a piece of tortoise-shell, and cut out the two round pieces. Melt some glue till rather liquid, thicken it with vermilion, lay a coat on the inside of the top and bottom of the box, and press in the two circles of tortoise-shell; in the same manner glue in the sides, leaving the lip (upon which the lid is to fit) standing up above the bottom part of the box. Leaving the glue to harden for a day, then replace the work on the lathe, turn the inside quite even, and polish it with pounce powder and oil, then with tripoli powder and water. Should the lid, when finished, become too small for the box, dip it for a minute in boiling water, fit it on to a piece of wood the exact size, and leave it there to harden.