BUILDING A COOLER.

Query.—W. G. H. writes: I have about completed a cooler except the floor and am undecided whether to make it of plank or cement. I thought you could give me the desired advice. One room is 16 feet square inside; 7 feet to joist with 7 feet of solid ice above, or about 50 tons capacity. The walls are 2 feet thick; 8 inches sawdust, 4 inches dead air space, 8 inches sawdust, with four thicknesses of one-inch boards, thus making the 2 feet. The building has these walls on all sides and partitions. I expect to use the drip from the above to cool another room, 8 feet by 16 feet inside, and will have the water run around this room in gutters (sheet iron) fastened to the wall. I want this as dry and as free from mould and dampness as possible and, therefore, am not sure as to whether a cement floor will be what is needed, though it was my intention to use cement. There is a 2-foot stone wall under the cooler which sets on sand—this sand having been washed up at times past by the lake. There are now fifty tons of ice over the cooler and back of this is an ice house, 16 feet square, inside filled with ice 14 feet high. This makes the building 20 feet wide by 48 feet long, by 20 feet studding. For ventilation a four-inch square flue will run from the bottom in one corner and from the top in the opposite corner of the cooler to the top of the roof, and above it, acting as chimneys. I want to use these coolers for fresh meats, packing hams and bacon, storing eggs and most anything that there is any money in, which requires to be kept in good condition. Your advice will be appreciated.

Ans.—You are building your cooler on very good plans. However, we would advise the use of cement for the floors. It will be found much better than wood, much purer and cleaner, and withal much drier. You speak about putting two ventilators in your cooler, which is all right, but you should be sure to provide these ventilators with slides, so you can shut them off and regulate the ventilation according to your wishes. Of course, you understand that it is not well to have the ventilators open all the time, as it would result in quite a loss of ice. The ventilators should be open only when the room needs ventilation, which will be at well-defined periods, or varying according to the amount of material in storage. Your plan of using the drip water of the ice and running it in pans will work all right. We have seen this method applied, and it was always satisfactory. Be sure to use galvanized iron gutters for the pans, not sheet iron, as it will rust easily.