A LIBRARY DESK
This is the most ambitious of the special problems in furniture making here suggested. Details are given in the drawings on the opposite page. If the young woodworker can give sufficient time to it and can command the services of a few machine tools it will not be an unreasonable task to undertake. Most of the operations required in its construction have already been carefully explained and need not be repeated as detailed directions. There are, however, one or two principles of cabinet-making called for in this problem which were not required in the others. They will therefore need explanation.
A library desk
Panelling.—To avoid the difficulties which would result from the swelling, shrinking, and warping of wide surfaces in furniture it is common practice to make use of the panel. The design of the panel is easily understood. It consists of a framework of ordinary thickness, put together usually with mortise and tenon joints. The inside edges of this framework are grooved, and into the groove is fitted a piece of stock generally thinner than the frame which fills the space between the sides of the frame. The panel board may be in one piece of wide stock or it may be glued up. It may be of very thin stock inset on both sides of the panel, or it may be of thicker stock inset only on one side, and perhaps not inset on either side, in which case only the edges of the board are made thin enough to run in the groove of the panel frame. In this problem the panel board is to be made of 1⁄2-inch stock, flat on the outside, and inset 1⁄4 of an inch. The back of the panel board is flush with the frame and is chamfered off to give the necessary tongue all around to run in the groove. The narrow stock of the framework is not likely to swell or shrink appreciably and, if well constructed, cannot become warped or twisted. The panel, on account of its greater width, may and generally does swell and shrink considerably; but it should be fitted to move easily in the grooves so that its changes may not be noticeable. Should it be desired to finish the panels with a moulding this should be nailed to the rails, not to the panel board.
Danger in the Power Saw.—The panel frame may be constructed by hand, but if a circular saw be available it will be found of great service. Beginners, however, should employ the services of an expert sawyer and not assume the great risk involved in the use of a circular saw or even a band saw, especially if these saws are without guards. The necessary operations should be carefully laid out on the partially finished stock, with a good square and gauge. A combination plane is quite essential for cutting the grooves; and this carries its own gauge. Care should be taken to make all measurements from the centre of the piece, and gauge and square always from the face sides and from the face edges of the joints. The cuts that it is necessary to make for the joints are indicated in the drawing. In gluing up, the directions already given in the section on gluing should be followed.
Sand-papering.—There is a legitimate use for sand-paper in the finishing stages of the work on this desk, as there is, in fact, in almost every kind of fine woodwork. Its use has already been advised in the directions for furniture making. In furniture manufactories sand-papering machines are among the most expensive machines to be found in the shops; and their high cost is of course justified by their productive value. It is quite impossible to work down large pieces to a good surface by the process of planing. If a sand-papering machine is within easy reach of the amateur cabinet-maker, it will be very desirable for him to send all large pieces like the tops of tables and panel boards to the factory in order to have them run through the machine. The expense is very slight. In sand-papering by hand considerable pressure should be applied as evenly as possible and always along the grain. Any movements directly across the grain or at an angle are sure to show through the finish. The process is facilitated by wrapping the sand-paper around a block of wood about 2 × 4 inches in diameter or, better still, a block of cork of the same dimensions.