RE-FINISHING OLD FURNITURE
There is nothing that affords more satisfaction to one looking for pleasing effects in household fittings than the occasional piece of genuine old furniture repaired and re-finished. Some of the rare old colonial designs are of exceptional merit. This is proved by the high prices which they often command. These designs originated in the days of the genuine hand crafts, before the invention of machine-made, cheap furniture. The work of the older designers was characterized by a certain individuality which gave it artistic value; and the craftsmen who worked out these designs did their work with such care and thoroughness that what they produced has had a lasting quality. It is for these reasons that we find it still in existence and so much desired.
Caution as to Repairs.—In the work of renovating old furniture, problems are met which are very different from those which have to be considered in the production of new work. All questions of design are settled. There is generally enough of the original article to show what the design was. The problem is one of restoration; we must supply the missing parts and re-finish the whole. The first thing to do, therefore, with any piece of genuine antique furniture is to look it over carefully from the point of view of the cabinet-maker, note its defects, supply the missing or loosened parts, and mend the breaks. It will be found that the wood is generally exceedingly dry and brittle on account of its age, and that it will therefore need to be handled more carefully than new wood; and, in matching up, it will often be found desirable to make use of parts of other old pieces rather than to add new wood to the old. This is especially true of veneering, which cannot be well matched in any other way. Old bits of veneer, on the other hand, may be so deftly fitted into the spaces where they are needed that the grafting is entirely obscured by subsequent finishing.
Scraping.—After the necessary repairs have been made, the next thing to be done is to remove the old finish. If the varnish is dry and brittle and somewhat cracked, it may be removed by means of a well-sharpened scraper, great care being taken, however, not to injure the wood surface, especially at the corners and edges. If the scraper does not take off the varnish well at certain points, fine sand-papering may be resorted to. It is generally wise, also, to give the entire surface a light sand-papering before it is cleaned up for finishing.
The Varnish Remover.—It often happens, however, that the scraper will not accomplish the desired result. In that case the liquid varnish remover is necessary. This may be found at the paint stores. The best formulas for producing these varnish and paint removers are known only to the manufacturers. It is therefore not wise for the young finisher to attempt to make his own remover. He should provide himself with a can of it and a bristle brush with which to apply it to the furniture. After putting on a good coat he should let it remain a few minutes and then try to scrape off the softened finish with a putty knife. If it doesn't come off readily, it should stand a little longer. The amount of time required depends entirely upon the hardness of the old finish. But in due time it will become soft and can be very quickly and effectually removed. A putty knife, however, will not remove it all. After scraping off as much as possible from the plain surfaces and from the corners, a careful washing with turpentine or benzine will clean off what remains. It is of the greatest importance that none of the old varnish nor any of the varnish remover should be permitted to remain. Either of them will show through the finish as stains on the broad surfaces and collect in the corners when the new finish is put on.
Re-finishing.—The re-finishing process is much like that described for new work, the chief exception being that there is generally no need of filling unless it has been found necessary to add new wood in making the repairs. Generally speaking, the re-finishing begins with the surfacing, which may be done with thin shellac coloured to match the stain of the furniture. This is sand-papered lightly before receiving the one or more coats of finishing varnish necessary to produce the desired effect. Very often all that is needed is a well rubbed down wax finish.