THE PROCESS
Preparing the Warp.—When the essential parts of the hand loom and their uses are understood, the amateur weaver is prepared to make ready the warp and attach it to the machine. The thread or warp is taken from spools or cones, four threads at one time, which constitute what is called a bout. After determining how many threads will be required, allowing so many threads to form one inch of the woven cloth, the operator must decide how wide her warp is to be and how long. With the width, the length, and the number of threads to the inch in mind, she proceeds to wind upon her warping bars or frame the requisite amount until she has it all in one great skein. In putting this upon the bars or frames she should be very careful to cross each bout—i. e., each four threads—so that one bout shall go above and one below, in order to allow the introduction of a pair of sticks, called lease-sticks or leash-sticks. These attachments keep the order of the threads so that they may be drawn into the harness in the same order in which they are wound on the beam.
Warping the Loom.—To warp the loom the operator loosens one end of the skein and, passing it from the warping bars to the loom, attaches it to the roller or beam at the back of the loom, after carefully dividing it so that it may be evenly distributed. At this point an attachment called a rake is firmly fastened to the loom by cords and a certain number of threads placed in each division. By the aid of the lease-sticks, which are inserted, and with the assistance of a second person to hold the skein firm, the threads are wound upon the beam. The rake is now removed and the worker proceeds to set up the piece.
Warping hook
Drawing in the Warp.—As has already been explained, two harnesses only will need to be used for simple weaving. Taking the first bout of four threads, the weaver draws the first thread through the centre of the first loop in the first harness, or the one to which the right-hand pedal is attached. The next thread is put through the centre of the first loop of the second harness, or the one attached to the left-hand pedal. The third is drawn through the second loop of the harness connected with the right-hand pedal, and the fourth, in turn, through the second loop of the harness attached to the left-hand pedal. Great care must be exercised that no mistakes are made; for a single misplaced thread means that the work of drawing in must be all done over again. A special kind of hook is used to assist in drawing in the warp. When the drawing in is completed properly, the operator begins at the right-hand side of the loom and, measuring the reed, allows one half the width of web from the centre of the reed and draws each thread through each dent in regular order. When this is done it is only necessary to connect the warp threads to the canvas of the beam by means of heavier threads which hold the warp out in the loom, test the work, and proceed joyously with the weaving.
Beating Up the Woof.—The weaver presses the right-hand pedal, and every alternate thread separates from the other, leaving a space between the two sets of warp threads for the shuttle to be thrown from right to left, carrying the woof threads through. The operator then draws this thread up at the side to make a good selvedge and brings home the beater, thus pressing the woof into the warp. A sheer fabric requires a light stroke of the beater, while firm cloth requires more force. Releasing the right pedal, the operator presses the left, which causes the warp threads to cross, holding more firmly the woof threads just thrown. The shuttle now passes from left to right, carrying through another woof thread which, in turn, is beaten up as before. So the work goes merrily on with the throws of the shuttle alternating from right to left and from left to right, interspersed with the strokes of the beater.
Hand-Made Towels
[Plate VIII]