TO MAKE A LIMP LEATHER BOOK COVER
The Design.—The first step is to choose the book to be bound. For the sake of simplicity, as perhaps the first piece of bookbinding undertaken, it should be a folio or "section." And it should be worth binding in leather. The subject, the paper, and the typography should be worthy of the distinction.
Typical arrangements suitable for tooled leather covers of books. Details of tooling, relief, etc., worked out as in other problems.
The Process.—If the book selected is already bound or "cased" it is necessary first to remove the binding or casing. Then at least three fly leaves should be added, made up to match the other leaves of the folio. A piece of bookbinders' linen or buckram is now cut to the size of the open folio, placed upon it like a cover, and, with the fly leaves and the folio itself, stitched through the back with silk of a colour to harmonize with the leather.
The next step is to prepare the leather cover. To do this, first place the leather in position on the closed folio and, allowing 1⁄4 of an inch at the top and bottom and 3⁄8 of an inch at the fore edge, mark and cut out the stock for the cover. The decoration, if there is to be any, may now be tooled on. If the design is heavy enough in relief to need a backing, it may be at once filled with cotton batting, pasted in as directed in the problem of the mat, and covered with thin paper.
Stock for the end papers is now selected. They may be of cover paper, or of silk, and they should harmonize in colour with the leather. They are formed of two thicknesses of the material chosen, by folding it over to fit into the part between the linen and the first fly leaf. If of paper they are to be cut to the length of the folio leaves, but the width is to be left with an allowance for adjustment after the linen is pasted in. If the end leaves are to be of silk, an allowance of 1⁄4 of an inch must be left for turning in at the top, the bottom and the fore edge.
We are now ready to paste the linen to the leather. Strong paste, with perhaps a little thin glue added, is needed for this part of the process. Now paste the outside end leaves to the linen on the inside of the cover; and, if silk has been used for these leaves, paste the other two to the outer fly leaves. Finally, the book should be placed under very gentle pressure and kept in this condition until dry. Care should be exercised to adjust this pressure to the character of the tooling, if there is any, so as not to crush it.