AMBU COMBINATION LINK MOULD
Using both sides, this mould casts five of the most used connectors for all batteries, using Standard Jars, 7-9-11-13-15 Plate four end connectors (two Dodge Tapers and two Standard Tapers, Negative and Positive), one end connector, ⅜-inch wire leed used on 12-volt Maxwell and other cars using wire leed. One small wire leed to connect with end post on storage battery requiring direct connection. Post support rings, which fit the two sizes standard rubber covers; also fit perfectly all posts cast with our post mould. Two handy washers that sometimes are badly needed when installing a new or rent battery.
Figure 8A[[1]]
Extra taper plugs can be furnished, also extra bushings for different size cable. Standard equipment as furnished includes four taper plugs, one large and one small cable bushing.
The top connectors most frequently replaced are the taper end connections and end connections with wire cable leads. For battery men desiring these parts, but not the large combination link mould, the AMBU-Washburn terminal mould, Figure [9], has been designed. It has the same general good features of the larger mould, and casts four end connectors, one wire cable leed and two washers.
Figure 9[[1]]