A Water-Cutter
A Water-cutter
The cut-water is best made of tin or lead, but stout cardboard or wood will serve the purpose. First cut the material into a round, and then make teeth in it like a saw. Thus:—Then bore two holes in it, as in the drawing, and thread strings through them, tying the strings at each end. Hold the strings firmly, and twist them a little. Then, by pulling at them to untwist them, the cut-water will be put in motion, first one way, while they are being untwisted, and then the other, while they twist up again. If held just over a basin of water, the notches will send spray a great distance, but you must be careful to dip them only when the cut-water is revolving away from you, or you will be soaked.