FRAMING
This is a subject on which volumes have been written. The general arrangement with the names and sizes of the various members is shown in the drawing, a design for a small cottage, or bungalow. ([Fig. 227].)
The heavy timbers forming the sill are cut to the outside dimensions of foundation and halved at the corners. Fasten the joints with ten or twelve penny nails. Cut all corner posts exactly the same length, toenail at corners to sill, and hold in position by temporary braces. Plumb the posts as the braces are nailed. Two boys must work at this job, one holding the plumb and the other nailing the braces. Cut and halve the ends of plate the same length as sill, and nail to corner posts. Cut 2 × 4 studs same length as posts, then nail to sill and plate 16 inches apart on centres. The openings to be left for doors and windows will break up the even spacing of the studs, but it should be made as uniform as possible. The spaces for door and window frames are to be enclosed with double studs to give the necessary strength. Corner braces are very desirable and in the old-fashioned braced frame were mortised into plate and post, and sill and post. ([Fig. 227a].)
Fig. 227. Corner framing
Fig. 227a. Frame of bungalow
For a simple structure the necessary bracing may be obtained by "letting into" the studding 3 × 1 inch strips, as shown in drawing. To do this hold the brace in the position it is to occupy, and make a pencil mark on both sides of it on each timber, sawing on the inside of these lines to a depth equal to thickness of brace. Remove the wood between saw cuts with a chisel. Test to see that brace comes flush with outside of studs, and nail securely in position.
When the frame is finished up to the roof the putting on of the siding may begin at any time.