Handbook of Railroad Construction; For the use of American engineers. / Containing the necessary rules, tables, and formulæ for the location, construction, equipment, and management of railroads, as built in the United States.

by George L. Vose

GENERAL ESTABLISHMENT OF ROUTE.

22. The straight and level line connecting any two points, is of course the best for the completed road; but this is seldom practicable. Way towns must be accommodated to a certain extent; but the main line should not be lengthened on that account, unless the traffic and capital furnished by such town is not only sufficient to pay for the construction and maintenance of the extra length, but also to carry the entire through traffic over such increased distance. If the town is unable to support such a burden, it may be able to build and maintain a branch.

23. Routes placed upon the immediate bank of a large stream, are generally crossed by a great number of deep gorges, which serve to drain the side lands.

24. Routes placed upon sloping land, when the axis of the road and the natural descent are at right angles to each other, are more subject to slides than when placed upon plateaus or “bottoms.”

25. Lines crossing the dividing ridges of separate waters, rise and fall a great deal; thus rendering necessary a strong motive power to work the road. Such roads are the Western of Massachusetts, passing from the valley of the Connecticut at Springfield, to the Hudson River valley at Greenbush. Also those roads crossing the Alleghanies. And such will be the Pacific road, crossing first the Rocky Mountains to the Great Basin, and second, the Sierra Nevada into the Sacramento valley.

CHAPTER I.
RECONNOISSANCE.

26. The object of the reconnoitre is to find approximately the place for the road, (i. e. within half of a mile,) to find the general form of the country, and to choose that part which with reference to the expected traffic, shall give the best gradients; to determine the elevations of summits upon competing routes; and, in fine, to prepare the way for the survey.

GENERAL TOPOGRAPHY.

27. The general topography of a country may be ascertained by reference to State maps, where such exist, and when not, by riding over the district. The direction and size of watercourses, will show at once the position of summits.

Fig. 1.

28. Water flowing as in fig. 1, indicates a fall from B to E; and also traverse slopes from a a and c c to d d.

Fig. 2.

29. Fig. 2 shows a broken ridge a a a from which the water flows in both directions; and in general, the sources of streams point towards the higher lands.

Fig. 3.

30. If it be required to join the points A and D by railroad, (fig. 3.) it may be better to pass at once from A through B and C, than to go by the streams F E, F′ E′. By the latter route the road would ascend all of the way from A to E; and descend from E′ to D. By the first if it requires steep gradients to rise from A to B, and to fall from C to D, still if the section B C is a plateau, and if the rise between A and B and A and E is the same, by grouping the grades at B and C we may so adapt the motive power, as to take the same train from A to D without breaking. The general arrangement of grades by the line A B C D is then as fig. 4; and A F E E′ F′ D, as in fig. 5. The saving in this case is by length, as the same amount of power is required to overcome a given ascent.

Fig. 4.

Fig. 5.

31. Valleys generally rise much faster near their source, than at any point lower down; also the width increases as we approach the debouch. Fig. 6 shows the cross sections of a valley from its source to the mouth.

Fig. 6.

32. In the case of parallel valleys running in the same direction, the form will be as in fig 7. Let 1 2, 1 2, etc., represent a datum level, or a horizontal plane passing through the lowest point. The line a b, shows the height of the bottom at B; c d that at D, e f that at E, and g h that at C. The broken lines i, k, l, m, n, show the general form of the land. Now by the route m m m m, from A to F, we have the profile m m m m, fig. 8, by n n n n, the profile n n n n, and by o o o, the profile o o o.

Fig. 7.

Fig. 8.

Fig. 9.

33. In the case of parallel valleys running in opposite directions, as in fig. 9, we have the form there shown; and the profiles corresponding to the several lines are shown in fig. 10. As we should always adopt the line giving the least rise and fall, other things being equal, it is plain which line on the plan we must follow.

Fig. 10.

34. In passing from A to B, figs. 11 and 12, by the several lines c, d, e, f, we have the profiles shown at c, d, e, f, from which it appears, that the nearer we cross to the heads of streams, the less is the difference of heights.

Fig. 11.

Fig. 12.

Fig. 12 (a).

35. If we wish to go from A to B, fig. 12 (a), we should of course take first the straight line; but being obliged to avoid the hill C, on arriving at d, we should not try to recover that line at e, but proceed at once to B. Also as we are obliged to pass through d, we ought to go directly to d and not by the way of c; and the same idea is repeated between A and d; the last line being A b d B. Few rules can be given in the choice of routes. Practice only will enable the engineer to find the best location for a railroad.