DRY-EARTH PRIVY
Pail type.—A very serviceable pail privy is shown in Figures [7] and [8]. The method of ventilation is an adaptation of a system that has proved very effective in barns and other buildings here and abroad. A flue with a clear opening of 16 square inches rises from the rear of the seat and terminates above the ridgepole in a cowl or small roofed housing. Attached to this flue is a short auxiliary duct, 4 by 15 inches, for removing foul air from the top of the privy. In its upper portion on the long sides the cowl is open, allowing free movement of air across the top of the flue. In addition, the long sides of the cowl are open below next to the roof. These two openings, with the connecting vertical air passages, permit free upward movement of air through the cowl, as indicated by the arrows. The combined effect is to create draft from beneath the seat and from the top of the privy. The ventilating flue is 2 by 8 inches at the seat and 4 by 4 inches 5 feet above. The taper slightly increases the labor of making the flue, but permits a 2-inch reduction in the length of the building.
Fig. 7.—Pail privy. Well constructed, ventilated, and screened. With proper care is sanitary and unobjectionable
Click on image to view larger size.
In plan the privy is 4 by 4½ feet. The sills are secured to durable posts set about 4 feet in the ground. The boarding is tight, and all vents and windows are screened to exclude insects. The screens may be the same as for pit privies or, if a more lasting material is desired, bronze or copper screening of 14 squares to the inch may be used. The entire seat is hinged, thus permitting removal of the receptacle and facilitating cleaning and washing the underside of the seat and the destruction of spiders and other insects which thrive in dark, unclean places. The receptacle is a heavy galvanized-iron garbage can. Heavy brown-paper bags for lining the can may be had at slight cost, and their use helps to keep the can clean and facilitates emptying. Painting with black asphaltum serves a similar purpose and protects the can from rust. If the contents are frozen, a little heat releases them. Of nonfreezing mixtures a strong brine made with common salt or calcium chloride is effective. Two and one-half to 3 pounds of either thoroughly dissolved in a gallon of water lowers the freezing point of the mixture to about zero. Denatured alcohol or wood alcohol in a 25 per cent solution has a like low freezing point and the additional merit of being noncorrosive of metals. The can should be emptied frequently and the contents completely buried in a thin layer by a plow or in a shallow hand-dug trench at a point below and remote from wells and springs. Wherever intestinal disease exists the contents of the can should be destroyed by burning or made sterile before burial by boiling or by incorporation with a strong chemical disinfectant.
Fig. 8.—Pail privy
Click on image to view larger size.
Fig. 9.—A well-ventilated privy in Montana
A privy ventilated in the manner before described is shown in [Figure 9]. The cowl, however, is open on four sides instead of two sides as shown in Figures [7] and [8]. The working drawings (figs. [7] and [8]) show that the construction of a privy of the kind is not difficult. [Figure 10] gives three suggestions whereby a privy may be conveniently located and the approach screened or partially hidden by latticework, vines, or shrubbery.
Vault type.—A primitive and yet serviceable three-seat dry-earth privy of the vault type is shown in [Figure 11]. This privy was constructed in 1817 upon a farm at Westboro, Mass. The vault, made of bricks, was 6 feet long by 5 feet wide, and the bottom was 1 foot below the surface of the ground. The brickwork was laid in mortar, and the part below the ground surface was plastered on the inside. The outside of the vault was exposed to light and air on all four sides. Across the long side of the vault in the rear was a door swinging upward through which the night soil was removed two or three times a year, usually in the spring, summer, and fall and hauled to a near-by field, where it was deposited in a furrow, just ahead of the plow.
Especial attention is called to the shallowness of the vault and the lightened labor of cleaning it out. The swinging door at the rear facilitated the sprinkling of dry soil or ashes over the contents of the vault, thus avoiding the necessity of carrying dirt and dust into the building and dust settling upon the seat. This privy was in use for nearly 100 years without renewal or repairs. When last seen the original seat, which always was kept painted, showed no signs of decay. Modern methods would call for a concrete vault of guaranteed water-tightness,[3] proper ventilation and screening, and hinging the seat.
[3] Directions for mixing and placing concrete to secure water-tightness are contained in Farmers' Bulletin 1279-F, "Plain concrete for farm use," and Farmers' Bulletin 1572-F, "Making Cellars Dry."
Working drawings for a very convenient well-built two-seat vault privy are reproduced in Figures [12] and [13]. The essential features are shown in sufficient detail to require little explanation. With concrete mixtures of 1:2:3 (1 volume cement, 2 volumes sand, 3 volumes stone) for the vault and 1:2:4 for the posts there will be required a total of about 2 cubic yards of concrete, taking 3½ barrels of cement, 1 cubic yard of sand, and 1½ cubic yards of broken stone or screened gravel. The stone or gravel should not exceed 1 inch in diameter, except that a few cobblestones may be embedded where the vault wall is thickest, thus effecting a slight saving of materials.
Fig. 10.—Screening the approach to a privy. A, Raised platform with lattice sides, suitable for short distances, convenient, and easily cleared of snow; B, walk hidden by latticework; C, walk inclosed by an arbor