LIST OF ATTACHMENTS FOR TRACTION ENGINE AND BOILER.
The following list of brasses, etc., which are packed with the Case traction engine will be useful for reference in connection with any similar traction engine and boiler. The young engineer should rapidly run over every new engine and locate each of these parts, which will be differently placed on different engines:
- 1 Steam Gauge with siphon.
- 1 Safety Valve.
- 1 Large Lubricator.
- 1 Small Lubricator for Pump.
- 1 Glass Water Gauge complete with glass and rods.
- 2 Gauge Cocks.
- 1 Whistle.
- 1 Injector Complete.
- 1 Globe Valve for Blow-off.
- 1 Compression Grease Cup for Cross Head.
- 1 Grease Cup for Crank Pin.
- 1 Oiler for Reverse Block.
- 1 Glass Oiler for Guides.
- 1 Small Oiler for Eccentric Rod.
- 1 Cylinder Cock (1 is left in place.)
- 2 Stop Cocks to drain Heater.
- 1 Stop Cock for Hose Coupling on Pump.
- 1 Bibb Nose Cock for Pump.
- 1 Pet Cock for Throttle.
- 2 Pet Cocks for Steam Cylinder of Pump.
- 1 Pet Cock for Water Cylinder of Pump.
- 1 Pet Cock for Feed Pipe from Pump.
- 1 Pet Cock for Feed Pipe from Injector.
- 1 Governor Belt.
- 1 Flue Cleaner.
- 15 ft. 1 in.
- Suction Hose.
- 5 ft. Sprinkling Hose.
- 1 Strainer for Suction Hose.
- 1 Strainer for Funnel.
- 4 ft. 6 in. of in. Hose for Injector.
- 5 ft. 6 in.
- of in. Hose for Pump.
- 2 Nipples ¾×2½ in. for Hose.
- 2 ¾ in. Hose Clamps.
- 2 ½ in. Hose Strainers.