(90) Vibrator Construction.
Since the efficiency of the high tension coil depends largely on the construction and efficiency of the vibrator, the different coil makers have developed various types of vibrators that differ greatly from the simple device shown in the coil diagram in details.
Fig. 95. Kingston Vibrator.
The main objects in view in the construction of a successful vibrator are:
1. To reduce the weight of the moving part as much as possible in order to increase the speed of vibration, and to make the trembler instantly responsive to the timer.
2. To cause the contact points to separate as rapidly as possible in order to cause the maximum spark.
3. To have the contacts as hard and infusible as possible to resist wear and the action of the spark between the contacts.
4. To make any adjustments that may be required, due to wear, as simple and accessible as possible.
The types of vibrators are legion, and we have not the space to go into the details of all the prominent makes, but will illustrate and describe two well known types.
The Kingston vibrator made by the Kokomo Electric Company, is a good example of a modern vibrator and is shown in detail by Fig. 95. All adjustments between the contact points are made by means of the contact screw A which carries a platinum point at its inner end. The retaining spring D keeps the contact screw from being jarred out of place by the engine vibration, without the use of lock nuts. Turning A against the vibrator, the tension of the spring B is increased, raising the screw decreases the tension. Increasing the tension screw increases the length and heat of the spark, and also increases the current consumption. At N is a separate thin iron plate which is acted on by the magnetized core, a rivet fastening the plate to the main vibrator spring is shown at the end of the spring. The current enters through the lug C, and from this point the circuit is the same as shown in the coil diagram.