2.—Bread-making by the Old Method.
To make a sack of flour into bread the baker takes the flour and empties it into the kneading trough; it is then carefully passed through a wire sieve, which makes it lie lighter and reduces any lumps that may have formed in it. Next he dissolves 2 oz. of alum (called in the trade “stuff” or “rocky”) in a little water placed over the fire. This is poured into the seasoning tub with a pailful of warm water, but not too hot. When this mixture has cooled to a temperature of about 84 degrees, from 3 to 4 pints of yeast are put into it, and the whole having been strained through the seasoning sieve, it is emptied into a hole made in the mass of flour and mixed up with a portion of it to the consistency of thick batter. Dry flour is then sprinkled over the top. This is called the quarter-sponge, and the operation is known as “setting.” The sponge must then be covered up with sacks, if the weather be cold, to keep it warm. It is then left for three or four hours, when it gradually swells and breaks through the dry flour laid upon its surface. Another pail of water impregnated with alum and salt is now added, and well stirred in, and the mass sprinkled with flour and covered up as before. This is called setting the half-sponge. The whole is then well kneaded with about two more pailfuls of water for about an hour. It is then cut into pieces with a knife, and to prevent spreading it is pinned, or kept at one end of the trough by means of a sprint-board, in which state it is left to “prove,” as the bakers call it, for about four hours. When this process is over the dough is again well kneaded for about half an hour. It is then removed from the trough to the table and weighed into the quantities suitable for each loaf. The operation of moulding, chaffing, and rolling up can be learnt only by practice.