Ribs under Compression.
For those ribs contiguous to the interstrut joints, a different construction is necessary to withstand the tension of the cross-bracing of the planes and, to a lesser degree, the internal plane wiring, so that at this point the rib performs two functions, that of maintaining the wing curve, and also taking the strains due to compression. Where such provision is not made, the tension of the wiring will result in either or possibly both of the following: (1) the rib will buckle laterally; (2) the camber will increase to an extent varying with the pressure on the wires, both results being extremely detrimental to efficiency. In this respect the old box-kites of varying origin used to offer some interesting studies in variable camber, and when it is remembered that the wing ribs were commonly composed of a single ash lath, steamed to shape, and the fabric attached on the top side only, the wonder is that extended flying was possible at all. For all that, some comparatively classic cross-country flights were accomplished. One popular system is to incorporate a box-rib at these points, sometimes made by placing two ordinary ribs close together and connecting them with three-ply or thin spruce, so that, although the overall width of the finished box-rib would be approximately 2 in., it is exceptionally rigid and withal light.
Fig. 33.—Compression rib.
Another solution is to use a solid web, lightly channelled out, as in [Fig. 33].
In some wing structures the ribs are uniform throughout, a strut of either steel tube or wood being inserted and to which the internal wiring is attached. This latter method is possibly more desirable, that is, if the joint between the compression strut and spar can be combined with the interstrut fitting. This may necessitate a little extra work in the latter, but this is preferable to the use of a separate fitting, involving additional piercing of the spar.