Controller for a Small Motor
Reverse for Motor
An easy way of making a controlling and reversing device for small motors is as follows:
Cut a piece of wood (A) about 6 in. by 4-1/2 in., and 1/4 in. thick, and another piece (B) 6 in. by 1 in., and 1/4 in. thick. Drive a nail through this near the center for a pivot (C). To the under side of one end nail a copper brush (D) to extend out about an inch. On the upper side, at the same end, nail another brush (E) so that it projects at both sides and is bent down to the level of the end brush. Then on the board put a semi-circle of brass-headed tacks as shown at F, leaving a small space at the middle and placing five tacks on either side, so that the end brush will come in contact with each one. Connect these tacks on the under side of the board with coils of German-silver wire, using about 8 in. of wire to each coil. Fix these by soldering or bending over the ends of the tacks. Then nail two strips of copper (G) in such position that the side brush will remain on the one as long as the end brush remains on the tacks on that side.
Put sides about 1-1/2 in. high around this apparatus, raising the board a little from the bottom to allow room for the coil. A lid may be added if desired. Connect up as shown.
Contributed by Chas. H. Boyd, Philadelphia.