Shipping Honey in Frames.
To do this properly and safely make the box or case in which you ship only wide enough to receive the length of the top bar of your frames, and one and a half inch deeper than the depth of the frame. Make the case tight and pitch the inside with rosin and bees wax, so that the leakage of the combs will not be lost.
In packing the frame honey, first pierce the projection of the frames through with an awl, invert it and place in the holes one inch finishing nails, then place the top of the frame down and crossways in the case, and with a tack hammer drive your nails. Place the next frame by the side of this first, corresponding as built in the hive, if it can be; and place them so as slightly to touch. In filling the last end of the case, place an iron rod on the head of the nail to drive it, as you cannot play the hammer.
When the case is full, take two strips (common lath) just long enough and wide enough to fill the case tightly from end to end, and cover the ends of the frames and fit tightly against the sides of the case; drive an inch nail through the strips in the end piece of each frame, and the frames will be perfectly solid.
I shipped from one to two hundred pounds in a case, in this manner, and Mr. Perrine tells me the average was not over two frames broken down per case, and no loss from leakage, the boxes being pitched inside.
A. Salisbury.
Camargo, Ills., Sept. 6, 1870.
[For the American Bee Journal.]