THE POACHER'S' SNARE.
Our next example represents one of the oldest and best snares in existence,—simple in construction, and almost infallible in its operations. It is the one in most common use among the poachers of England, hence its name. The pieces are three in number, and may be cut from pine wood, affording easy and profitable employment for the jack-knife during odd hours and rainy days, when time hangs heavily.
The pieces are so simple in form and easy of construction that a sufficient number for fifty traps might be whittled in less than two hours, by any smart boy, who is at all "handy" with his jack-knife.
If a few good broad shingles can be found, the work is even much easier,—mere splitting and notching being then all that is necessary. The bait stick should be about eight inches long, pointed at one end, and supplied with a notch in the other at about half an inch from the tip. The upright stick should be considerably shorter than the bait stick, and have a length of about ten inches, one end being nicely pointed, and the broad side of the other extremity supplied with a notch similar
to the bait stick. About four inches from the blunt end, and on the narrow side of the stick, a square notch should be cut, sufficiently large to admit the bait stick loosely. The catch piece now remains. This should be about two and a-half inches in width, and bevelled off at each end into a flat edge. The shapes of the different pieces, together with their setting, will be readily understood by a look at our illustration.
A hundred of these pieces will make a small bundle, and may be easily carried by the young trapper, together with his other necessaries, as he starts off into the woods. He will thus be supplied with parts for thirty-three traps, all ready to be set, only requiring the stakes for the pens, which may be easily cut in the woods. Having selected a flexible sapling about five feet in length, and having stripped it of its branches, proceed to adjust the pieces. Take one of the upright sticks, and insert it firmly in the ground, with its upper notch facing the sapling, and at about four feet distant from it. Bend down the "springer," and by its force determine the required length for the draw-string attaching one end to the tip of the sapling, and the other near the end of a catch piece, the latter having its bevelled side uppermost. The wire noose should then be attached to the draw-string about six inches above the catch-piece. The pen should now be constructed as previously directed. Its entrance should be on the side furthest from the springer, and should be so built as that the peg in the ground shall be at the back part of the enclosure. The pen being finished, the trap may be set.
Insert the bait stick with bait attached into the square notch in the side of the upright peg; or, if desired, it may be adjusted by a pivot or nail through both sticks, as seen in our illustration, always letting the baited end project toward the opening. Draw down the catch piece, and fit its ends into the notches in the back of the upright peg and extremity of the bait-stick. By now pulling the latter slightly, and gently withdrawing the hand, the pieces will hold themselves together, only awaiting a lift at the bait to dislodge them. Adjust the wire loop at the opening of the pen, and you may leave the trap with the utmost confidence in its ability to take care of itself, and any unlucky intruder who tries to steal its property.
Most of the snares which we shall describe are constructed from rough twigs, as these are always to be found in the woods, and with a little practice are easily cut and shaped into the desired forms. If desired, however, many of them may be whittled from pine wood like the foregoing, and the pieces carried in a bundle, ready for immediate use. In either case, whether made from the rough twigs or seasoned wood, it is a good plan to have them already prepared, and thus save time at the trapping ground when time is more valuable.