Wing Warping
In some monoplanes with the inverted V wing arrangement, a dipping of one wing answers, so to speak, to increase its concavity and thus to augment the lifting force on that side. The sketch shows the normal and distorted arrangement of wings: the inner limb being the one bent down in rounding a curve. An equivalent plan was to change the angle of inclination of one-half the sail by swinging it about a horizontal pivot at the center or at the rear edge: some machines have been built with sails divided in the center. The obvious objection to both of these plans is that too much mechanism is necessary in order to distort what amounts to nearly half the whole machine. They remind one of Charles Lamb’s story of the discovery of roast pig.
Wing Warping
The distinctive feature of the Wright machines lies in the warping or distorting of the ends only of the main planes. This is made possible, not by hinging the wings in halves, but by the flexibility of the framework, which is sufficiently pliable to permit of a considerable bending without danger. The operator, by pulling on a stout wire linkage, may tip up (or down) the corners cc´ of the sails at one limb, thus decreasing or increasing the effective surface acted on by the wind, as the case may require. The only objection is that the scheme provides one more thing for the aviator to think about and manipulate.