A stick about three inches long, with a very small pulley attached near the end, should be fastened in the peak of the roof for a
Feed-hoist (see [Fig. 238]).
The first story has
A Drop-front, as shown in [Figs. 238] and [239]. This is made from the box-cover. Fasten the boards together with battens placed upon the inside, and hinge it to the bottom of the stable. Nail two cleats to the under side of the floor (see [Fig. 238]) to lift it off the ground just enough to allow the front to drop without springing its hinges.
When the front is down it forms an incline upon which to run the horses into the stable. For this reason it is not advisable to cut an opening in it, but merely
Represent a Stable Door on the outside (see [Fig. 238]). This is done with paint and a fine brush. First paint a green panel in the center of the front, and then mark off a couple of panels within this space with black paint, and stripe them diagonally to represent beaded-boards.
With strips of wood half an inch wide make
A Simple Trim around the door, the sides of the stable, and around the gable, as shown in the illustration.
When the carpenter work has been finished,