Fig. 275.—A Bed.
Fig. 276.—Another Design.
Make the head and foot pieces three by four and one-half inches, cutting a piece two by an inch and one-quarter out of the top of each as shown in the drawing ([Fig. 276]6), and using the pattern of the other bed for cutting the curve in the bottom edge. Nail the pieces together in their proper places, after which cut some slats and fasten them in the bottom.
The Dresser ([Fig. 277]) is made somewhat similar to the side-board. Cut the sides by the same pattern ([Fig. 262]) and fasten them to the edges of the back piece, which should be six and one-half inches high by three inches wide. Cut shelf A three by one and one-quarter inches, B and C three by one and one-eighth, D three by one and three-sixteenths, and E and F one-half by one and one-quarter inches. Fasten shelf A between the sides at line No. 24 (see [Fig. 262]), B at line No. 23, C at line No. 22, D at line No. 21, and notch the ends of E and F to fit over the side pieces at line No. 20.
