Fig. 376. The Framework.
The adaption of a set of works to
An Automobile Touring-car is shown in Figs. [375] and [376], the former showing the little machine completed and the latter its frame with the clockworks fastened in place. The same scheme as that used for the cars of the toy railway described in the preceding chapter will be followed in making
The Frame of the automobile, as that is about the simplest way, and makes a light, easy-running vehicle. The bed will be cut of a different pattern, however, as will be seen in [Fig. 377]. Lay out the piece to the dimensions shown upon this drawing, and then cut it out, making a mortise in each end for the wheels to fit in. The spool wheels should be mounted in the same manner as those of the railway cars, for which see [Fig. 359], Chapter XXV, and the directions upon page [335]. One end of spool A should be pivoted with a longer finishing nail than those used for the other pivots, so that when driven in place about half an inch will project beyond the frame. A small silk spool should be fastened upon this for a belt-wheel (see B, [Fig. 377]). The hole in one of these spools is about three-sixteenths of an inch in diameter, so, in order to make it fit tightly upon the nail, it is necessary to fill in around the nail with sealing-wax. To do this, turn the wooden frame upon its edge and place the spool over the nail, being careful to get the nail in the exact centre of the hole. Then hold a stick of sealing-wax over the spool, and with a lighted match melt the end and allow it to drip into the hole. When the hole has been partially filled, allow the wax to harden a little, and then press it down around the nail with the end of a match, being careful not to throw the spool out of centre by doing so. The hole should then be filled to the top.
We are now ready to prepare the clockworks for mounting upon the wooden frame. The works shown in [Fig. 376] are from an alarm clock, but if you have a striking clock, or one with works a little different from those shown in the illustration, it does not make a bit of difference in the scheme for attaching the works. The three parts shown in the foreground of [Fig. 376] must first be removed from the works. These will be recognized readily in any clock, as they are pivoted close together, and regulate the speed of the other wheels. When they have been removed, the main-spring will unwind rapidly. The frame of the works shown in the [illustration] is held together with nuts, so that in removing the wheels it was necessary to unscrew two of them, spring the frame open enough to let the wheels drop out, and then replace the nuts again in their former positions. If the frame of your clockworks is riveted together, the wheels will have to be broken out. A small silk spool, such as B ([Fig. 377]), should be fastened upon the small pivot which originally operated the clock's hands, for a belt-wheel. Lay the works upon a table with the face-side down, and, after centring the hole of the spool upon the pivot, fasten it in place with sealing-wax in the same manner as you attached spool B.
The works should now be attached to the wooden frame. Place them with the striker uppermost, near the edge of the frame, so that the small belt-wheels are in line with one another. Then bore a number of gimlet holes in the wooden frame and run copper wire through them, passing it around the posts of the clock-frame and twisting its ends until the works are firmly fastened in place.
A rubber band about an eighth of an inch wide and long enough to reach from one belt-wheel to the other should be procured for
The Belt.—This should stretch just enough to cling upon the spools, as more than that would cause too much friction.