The "turning in" method has some advantages over the tin; one being that dogs cannot get in so easily, and another is that the fence will stand up better; the wide strip of tin or sheet-iron catching wind or snow which helps to sag the wire or cause the fence to lean. The tin or sheet-iron, however, seems to be the best in preventing any animal's escape.
The enclosure can be enlarged at any time, but do not make the mistake of beginning with too small an enclosure, as some have. Also have your fence about 7 feet high to keep dogs out, as well as to keep the fur-bearers in. Just how much the enclosure will cost depends upon several things: The cost of 9 foot, 1 inch mesh No. 16 galvanized wire is about $1.50 per rod. This price, of course, will vary some, depending upon where you are located. In some of the smaller cities you perhaps cannot get the kind you want and will be compelled to send to some of the larger cities or catalogue houses. Perhaps you can not get wider than 5 feet. If such is the case buy in two widths—5 feet and 4 feet. This will give you the desired height.
Posts as already mentioned should be of locust or some other long lasting wood, as cedar, and should be thoroughly seasoned before putting in the ground. The posts should be fully 6 inches in diameter. If from larger locust and split, so much the better, as the older the tree the longer it will last. The cutting and setting of the posts, putting up of the fence, can be done by the "fur-farmer" in those sections where locust and cedar grow, so that all the cash outlay necessary in building the enclosure, will be for galvanized wire, some staples and sheet tin for the top. Instead of placing the tin around the top, it may be fastened on the inside of the wire (as shown), about four feet from the ground.
The corner posts should be two or three times larger than the others; they should be set more firmly in the ground, five feet being about right. This will necessitate these posts being two feet longer than the rest. They should be firmly braced in both ways.
Fence with Sheet Tin Four Feet from Ground.
The cost of fencing an acre, varies, of course. An acre contains 160 square rods or about 12-1/2 rods each side—equal to 50 rods of fence. If the wire costs $1.50 a rod, and posts 40 cents each, the cost of material required to enclose an acre will be $95.00. We are figuring on two posts to the rod. Add to this staples, gates, etc., and the cost will perhaps be about $100.00. Of course a much cheaper wire could be used, poorer posts, etc., so that the cost would be greatly reduced—but it generally pays to do a thing well.
To enclose a certain amount of ground with the smallest number of rods of fencing possible, the plat or ground to be enclosed should be in a square. The additional cost to enclose an acre, say 20 rods long by 8 wide, would be material for 6 additional rods. To fully illustrate, an acre fenced in a square would be 12-1/2 rods on each side, or 50 rods; if 20 rods long, the two sides would be 40 rods, and the ends 8 each or 16 rods, making a total of 56 rods.
While the cost of enclosing an oblong piece of ground would be a few dollars more than if square, this should not stand in the way if the oblong piece of ground would make a better home for your fur-bearing animals.
The persons who expect to make "fur-farming" a business, can begin in a small way and same need not interfere with other work to a great extent. Year after year, as they learn more of the business, they can enlarge, etc. Trappers, hunters and others who from experience know much of the animals, will no doubt be the most successful from the start. One party writes to know if skunk, fox, opossum and mink can be successfully raised in the same enclosure. If he means allowed to run together, they can not. If he means the same outside enclosure, with separate apartments for the various animals, there is no reason why such a place should not be successful as there will be advantages in such a plan.