Fig. 6. Dimensions of Double Swedish Sail.
N. B.–The mark (') means feet and (") means inches. party brought in was extra large; it measured approximately two yards and a half square. This was folded on itself, making a parallelogram seven feet six inches long and three feet nine inches wide. The sheets we had were all rather worn and some were badly torn, so that we had to make our sails of double thickness, sewing patches over
Fig. 7. Halyards Looped onto Pole. the weak spots. A broad hem was turned down at each end, and heavy tape was sewed on, leaving loops as before, to attach them to the spars. This reduced the length of our sail to seven feet three inches. The end spars were spaced apart by a light pole about ten feet long, to which they were
Fig. 8. The Double Swedish Sail. tied at the points of intersection. The spars were also braced by halyards looped over the ends of the pole in the manner indicated in the drawing (Fig. 7). It took a crew of two boys to manipulate this sail. In use, the pole of the rig was carried on the shoulders, and the sail was guided by means of ropes attached to the lower corners of the vertical spars. These ropes in nautical language are called “sheets.” The boy at the rear was the pilot and did the steering, because his position behind the sail gave him an unobstructed view in all directions. When changing tack the sail was lifted overhead to the other side of the crew.
Fig. 9. Changing Tack.
The Single Swedish Sail.