Fig. 131.—Stenobothrus sibiricus pairing: A. the ♂, fore tarsus (t) greatly enlarged; ar, arolia; p, pulvillus.—After Pagenstecher.
Simmermacher states that in most cases of climbing beetles the tubular tenent hairs pour out a secretion (Figs. 133, 134), “and it is probable that we have here to do with the phenomena not of actual attachment by, as it were, gluing, but of adhesion; the orifice of the tubes is divided obliquely, and the tubes are, at this point, extremely delicate and flexible, so as to adhere by their lower surface; in this adhesion they are aided by the secreted fluid.” In the case of the Diptera he does not accept the theory by which the movement of the fly along smooth surfaces is ascribed to an alternate fixation and separation, but believes in a process of adhesion, aided by a secretion, as in many Coleoptera. (In the Cerambycidæ there is no secretion, and the tubules are merely sucking organs, like those observed in the male Silphidæ.) “The attaching lobes, closely beset with chitinous hairs, are enabled, in consequence of the pressure of the foot, to completely lie along any smooth surface; this expels the air beneath the lobes, which are then acted on by the pressure of the outer air.” (Journ. Roy. Micr. Soc., 1884, p. 736.) Another writer (Rombouts) thinks this power is due to capillary adhesion.
Fig. 132.—Fore leg of ♂ Dyticus, under side, with sucker, formed of 3 enlarged tarsal joints: with a small cupule highly magnified. × 120.—After Miall.
The action of the pulvillus and claws when at rest or in use by the honey-bee is well shown by Cheshire (Fig. 135, B). In ascending a rough surface, “the points of the claws catch (as at B) and the pulvillus is saved from any contact, but if the surface be smooth, so that the claws get no grip, they slide back and are drawn beneath the foot (as at A), which change of position applies the pulvillus, so that it immediately clings. It is the character of the surface, then, and not the will of the bee, that determines whether claw or pulvillus shall be used in sustaining it. But another contrivance, equally beautiful, remains to be noticed. The pulvillus is carried folded in the middle (as at C, Fig. 105), but opens out when applied to a surface; for it has at its upper part an elastic and curved rod (cr, Figs. 105 and 135), which straightens as the pulvillus is pressed down; C and D, Fig. 135, making this clear. The flattened-out pulvillus thus holds strongly while pulled, by the weight of the bee, along the surface, to which it adheres, but comes up at once if lifted and rolled off from its opposite sides, just as we should pull a wet postage stamp from an envelope. The bee, then, is held securely till it attempts to lift the leg, when it is freed at once; and, by this exquisite yet simple plan, it can fix and release each foot at least twenty times per second.” (Bees and Bee-keeping, p. 127.)
Fig. 133.—Cross-section through a tarsal joint of fore leg of Dyticus, ♂, showing the stalked chitinous suckers (s), with a marginal bristle on each side: t, trachea; a, an isolated tubule or sucker of Loricera,—b, of Chlænius,—c, of Cicindela; d, two views of one of Necrophorus germanicus, ♂.
Fig. 134.—Section through the tarsus of a Staphylinid beetle; the glandular or tenent hairs arising from chitinous processes. A, section through the tarsal joint of the pine weevil, Hylobius abietis, showing the crowded, bulbous, glandular, or tenent hairs arising from unicellular glands.—This and Fig. 133 after Simmermacher.