Any places not inclined to stay put may be clamped down with strips of cardboard pinned on. The glass eyes should be placed now before setting away to dry, which will require some time.
When dry any bare patches of skin will have a dead appearance and require painting with oil colors thinned with turpentine to reduce the gloss. The end of the nose and lips are touched with varnish to produce the natural moist appearance.
If mounted with open mouth this is modelled in paper and wax coated as already described. The fur which should have been nicely combed after mounting will need another brushing and the animal is ready for removal to a permanent mount or pedestal. Some little judgment can be displayed in this selection as a poor, rough mounting will detract from the appearance of the best work while a specimen far below the average will pass muster with tasteful and suitable surroundings. The same principles will apply with some exceptions in mounting about all large animals.
Some of the most ponderous have a hollow wooden frame made to reduce the bulk of filling required; this is covered with wooden strips or lath and this in turn with a layer of fibrous material.
Supporting rods more than ½ inch in diameter must have both ends threaded and be connected with the back-board by iron squares. These consist of a rectangular piece of iron, bent at right angles and drilled with a number of holes in both flanges. One set of these is for screwing to the back-board while the others are of a size to receive the upper end of the leg rod. By changing these from one hole to another it is possible to vary the distance somewhat between the front and hind legs without moving the iron squares on the back-board.
Sometimes the hair will be found missing in one or more places on a finished animal and in such case "Old Dr. Le Page's Liquid Hair Restorer" is the only remedy. The place to be covered is coated with glue and a small tuft of hair from the same or another skin grasped with a forceps, the base touched with glue and carefully placed. The hair is arranged with a setting needle before the glue hardens, and though a tedious operation it may be performed so well as to defy detection.
Another way where the hair or fur is of some length is to procure a patch of the right size with hair matching that surrounding, shaving the hide thin, coating the back with glue and pinning on the bare spot.