DISTRIBUTOR
Distributor Bar
The distributor bar is suspended between the distributor screws, and is fastened to the distributor beam by two machine screws, and held rigid by dowel pins.
There are seven combination rails along the bar. These combination rails are cut away in various places, and certain of the rails or combinations terminate directly above each channel in the magazine entrance. The V-shaped end of the matrices have combinations or distributing teeth which engage these rails. The bar is adjusted to proper height and position so that the matrices, leaving the top rails of the distributor box, do not bind on the aligning plate at the back of the bar above the rails. These adjusting screws are in the top of the distributor beam and rest on the yoke. On the later machines the side-wise adjustment is made by an adjusting screw fastened to the beam and banking against the right side of the yoke.
Each matrix has a combination corresponding to the combination cut on the bar. The matrix is conveyed along the bar by the distributor screws. As soon as the matrix reaches the end of the rail corresponding to the combination on the matrix, it drops into the channel, which guides it into the magazine.
Channel Entrance
The channel entrance is connected to the rear end of the magazine on the magazine frame by two hinge screws. The entrance is held in position by a spring at the right side and fastened to the magazine frame.
The channel entrance consists of a number of flexible partitions, which are assembled in the channel entrance partition plate, and act as a guide for the matrices as they fall from the distributor bar into the magazine.
Each partition rests against the side of a tooth in the automatic stopping bar. If matrices become clogged in the entrance guides, they pile up until they come in contact with the distributor screws. This forces the partitions against the teeth of the automatic stopping bar which causes the distributor driving mechanism to stop.
At the bottom of the channel entrance, on each side, and banking against the magazine frame, are two adjusting screws which are used to adjust the position of the channel entrance. The adjustment is made to give the matrix free movement in transferring from the channel entrance to the magazine under the channel entrance matrix guard.