When ready to begin operations in the field, take out a quantity of the shoots to be used for cions, and keep them wrapped in damp cloth or packed in a box, basket or other receptacle with wet moss, to prevent drying. If any considerable number of stocks are to be grafted, then an assistant or two will be required, for the grafter cannot be alternately handling the knife and cions and wax, and do good work, but if he only inserts the cions and his assistant applies the waxed ligatures, the operation will proceed more rapidly and satisfactorily.
[FIG. 13]. SPLICE GRAFT.
[FIG. 14]. SPLICE GRAFT INSERTED.
Modes of Grafting.—The only two modes of grafting that I shall recommend for the chestnut are the splice or whip graft, and the cleft or wedge graft. In the splice graft, the cion and stock should be of about the same diameter, but if there is any difference let it be in favor of the stock, and this the largest. In this mode of grafting, the stock is cut off with an upward slope, exposing two or three inches of wood; and about midway on this slope a small cleft or incision is made, forming what is called a "tongue." The cion is then cut in the same way from the upper end downward, with a corresponding incision, as seen in Fig. 13. Then the two are neatly fitted together, the tongue on one entering the cleft on the other, making a close joint, as shown in Fig. 14. The bark of the cion and stock should be exactly even on one side at least; and if they are of the same size, so much the better, for then they will be even on both sides; but we cannot expect to secure such perfect joints on every stock, or any considerable number, although we aim to do so as frequently as possible. When the cion is fitted, the waxed paper is applied by placing one end of the strip at or near the base of the splice, then wind it spirally and firmly upward until the entire wound is covered. If one of the waxed strips is not enough use another, for it will do no harm if they are double on a part or all over the joint. The cion should not be much over four inches long, and a less length is preferable, but not so convenient for handling. One good prominent bud on each cion is sufficient, and this left near the upper end, but on short-jointed wood we may use cions with two or more buds without greatly increasing their length. After the cion is in place and every part of the splice is carefully sealed with the waxed paper, place a small piece or a little wax on the upper end of the cion, just enough to cover the exposed wound and prevent evaporation of the natural moisture or sap in the wood. I have found, in practice, that this sealing the end of the cion is time well spent; in fact, to leave any of the wood cells exposed to the air endangers the success of the operation.
Young shoots from a quarter of an inch in diameter up to five-eighths may be used for cions, in splice grafting; and with a little care in the selection of stocks, or by cutting them off a few inches higher or lower, we may readily manage to have them nearly of the same diameter to match our cions, whether they are large or small, and such unions will soon heal over, leaving no scar at the point where the two have been joined.
If the new growth or shoot to be employed as a cion is slender and feeble, then the base of the cion may be of two-year-old wood, leaving just a bud or two on the upper end of the one-year shoot. But it will seldom be necessary to employ such cions in grafting the chestnut, although it may occur when seeking to secure wood for propagation, from very old trees which have made only a feeble annual growth.
