Fig. D. (A and B are six inches from the ends.
The bow is bent slightly at C.)
Your bow is now finished as far as the wood-work is concerned, and you may proceed to wrap it from end to end with silk or colored twine, increasing its elasticity and improving the appearance. The ends of the wrap must be concealed as in wrapping a fish-hook. Glue with Spaulding’s glue a piece of velvet or even red flannel around the middle to mark your handhold. The ends may in like manner be ornamented by glueing colored pieces upon them.
A hempen string, whipped in the middle with colored silk, to mark the place for your arrow nock to be put, in shooting, will make a very good string.
For arrows any light, tough wood, which splits straight, will do. I use white pine, which may be gotten from an ordinary store-box, and for hunting-arrows seasoned hickory. These must be trimmed straight and true, until they are in thickness about the size of ordinary cedar pencils, from twenty-five to twenty-eight inches in length. They must be feathered and weighted either with lead or copper, or by fastening on sharp awl-points or steel arrow-points with wire.
I used to make six different kinds; a simple copper-wrap, a blunt leaden head, a sharp leaden head like a minie bullet, an awl-point wrapped with copper wire and soldered, and a broad-head hunting-arrow.
To make a copper wrap, wrap with copper wire the last half-inch of the arrow until you get near the end, then lay a needle as large as your wire obliquely along the arrow as in this figure: (Fig. E.) Continue the wrapping until you have weighted the arrow sufficiently; draw out the needle and thrust the end
Fig. E.