Fig. 10 is a parting tool, used to cut off work, and to make incisions.
Fig. 11 is used exclusively for very hard woods, as cocoas and ebony, which chip if attempted to be smoothed with a chisel; also for turning ivory, bone, or jet; one side and the end are sharp. This tool is very strong, and requires some practice to use it well. Be very careful, in sharpening it, to keep the front edge quite straight, or else, in hollowing out boxes, the inner sides will not be turned out evenly; that is, one part will be thinner than another. This tool is held flat upon the rest, which must be on a level with the axis of the work, or sometimes the tool, by raising the handle, may be lowered so as just to scrape the wood. It is frequently called a graver; in turning metals, it is the tool first used. Copper and brass are easy to turn, and in case of necessity, it is useful to have the proper tools, and to know how to manage them.
These tools all are indispensably necessary to the turner, and he should exercise himself constantly in their use; for until he becomes quite master of them, he will injure, spoil, chip, and destroy, whatever he attempts to turn.
Figs. 12 and 13 are very useful to make mouldings of various kinds.
The handles of the tools must be made of very hard wood, and it is a great convenience to have them all of nearly the same size; for the hand, getting accustomed to them, manages them with more facility. Drive the tool firmly into the handle, and hold it there by a broad brass ring, as in No. 1.
To keep the tools in good order, that is, properly ground and sharp, demands great attention. If they become chipped, grind them even on a grindstone, taking care that the BEVELS retain their proper angles. To avoid spoiling their edges, and to enable you to have them always near at hand, a rack perforated with holes, into which they can slip, is very useful. This rack may be fastened against the wall, near the lathe. A screw-driver, two or three different-sized gimlets, and nails of various kinds, must always form part of the turner’s tool-box; also some files, and a hand-vice.
Before we leave the description of turning tools, we will mention the saw, which is an indispensable addition to the tool-box. There are many kinds, but the most useful are the hand-saw, the tenon saw, and the circular saw. The first is about twenty-six inches long, and is generally made with four teeth to an inch. It is used for cutting wood across, and in the direction of its fibres. The teeth at the lower end are smaller than the upper ones, by which means the wood is not so much torn as if the teeth were all of an equal size. The tenon saw is used for cutting across the fibres of wood; the smallest saw of this kind is about fourteen inches long, the largest about twenty inches. Circular saws are of all sizes; they are easily fitted up with a spindle, which, being screwed on to the nose of the mandrel, and supported at the other end by the back puppet, enables the workman to turn them by the wheel of the lathe, while at the same time he holds the wood or ivory firmly against them. Should a larger circular saw be required, it is more advisable to fit it up separately from the lathe, with a frame-work and wheel to itself.
Glue, which is very necessary for turners, requires some little care in preparing; it must first be steeped for several hours in cold water to soften it; if it swells without melting, it is good, and must then be dissolved in water; the proper quantities are, a quart of water to half a pound of glue. The heat should be just enough to melt it, and the pan in which it is contained must be placed in a larger copper vessel, filled with water; by this means, when the water in the outer pan boils, the glue will be dissolved without any fear of its burning, which would immediately spoil it. When you are going to glue a piece of wood to a chuck, put very little glue thinly and evenly over the surface of the latter, then press the wood upon it firmly, and place a lead weight upon them to unite them perfectly.
CHUCKS.
