A very handy little tool for breaking up oil paint when mixing in a can instead of using a stick is shown in [Fig. 4] (see next page). Its shape enables it to be used also as a scoop or spoon for lifting the colour out of the kegs, etc. The patentee and manufacturer is H. Smith, Hale Road Bridge, Altrincham, Cheshire. The illustration shows both sides of the tool. The projection on the left hand of the carved blade is provided in order to reach beneath the rim of lever-top cans.
The Proportions of Materials.
—We come to a consideration of the proper proportions of materials, viz., white lead (or other white), oil, turpentine and driers—the colour we shall speak about shortly—to be used on various kinds of work.
Fig. 4.
A little consideration will make it quite clear that it is impossible to give exact proportions of materials that will suit every job. These proportions are determined by the condition of the work. A new door of good sound pine will be treated differently to one made of an inferior wood, which is knotty and somewhat sappy. Again, a door that has been exposed to the weather for some years, and from which the paint has, perhaps, almost wholly departed, will require a different mixture to a front door from which the accumulation of old paint, extending, perhaps, to over one hundred years, has been burnt off. Precisely in the same way as patent medicines cannot be safely used for any and every complaint, so it is impossible to have paints that will suit any and every purpose. In one case the doctor is consulted and he takes into consideration every symptom and every condition and acts upon his diagnosis or scrutiny of symptoms. In like manner the decorator takes note of every condition of his work, and prepares his paint accordingly. Again, iron would not be painted with the same mixture as wood. Still if we cannot give exact proportions, we can, at least, give some information on the subject, which will form a guide and give some data for the reader to work upon. These we will give under separate heads.
Priming for Iron.
—The usual plan is to use red lead mixed with linseed oil, the proportion required being about 14lbs. of linseed oil to every cwt. of lead. The second coat should be equal proportions of red and white lead mixed to a proper consistency with linseed oil. Sometimes oxide of iron paint is used instead of red lead.
Painting on Stucco.
—The priming must contain a considerable quantity of oil, because of the absorbent nature of the stucco, and it should have a big proportion also of turpentine. Four galls. of boiled oil to a cwt. of red lead and three quarts of turpentine will usually answer. The second coat should be an equal mixture of red and white lead with a smaller proportion of turpentine and oil.