Plate 12.
|
Figure 12. |
Figure 13. |
Figure 14. |
Method 1. If it is possible to have the handle support go through the drawer or door, the support may be made from a piece of square rod of the length desired, a hole being drilled through one end, the size needed, as at Figure 15[Figure 15], A. A shoulder is then made by filing the rod down to the size of the hole in the plate. In making the shoulder the remainder of the rod which is to go through the drawer front may be left square or filed round; as the hole is round that is drilled to receive it, this last is the better way. It is also easier to fasten it on the inside of the drawer when it is made in this way, for it may be simply headed up as in making a rivet, Figure 15 B, or a thread may be cut and a nut used, Figure 15 C, D. The latter method is better where taps and dies are at hand. When it is fastened by riveting, a circular or square piece of metal called a washer, Figure 15 E, a little larger in diameter than the bolt, with a hole the size of the bolt, is placed next to the drawer front on the inside; this makes the riveting more secure.
Figure 15.
Method 2. Another method for fastening this style of a handle is to cut a slot through the plate about 1/16 inch wide and length called for by the design, [Figure 16 A]. Then take a strip of copper in length 7 times the diameter of the handle end and as wide as the slot in the plate is long, [Figure 16 B]. This is then bent circular a little larger in diameter than the end of handle as at [Figure 16 C], and placed in the slot as at [Figure 16 D], and clinched on the back of the plate as at [Figure 16 E]. The plate is in this case fastened to the drawer or door by nailing or riveting.
