Sundial, or hunter's clock
{59}
To make a scout's sundial, prepare a smooth board about fifteen inches across, with a circle divided into twenty-four equal parts, and a temporarily hinged pointer, whose upper edge is in the middle of the dial. Place on some dead level, solid post or stump in the open. At night fix the dial so that the twelve o'clock line points exactly to north, as determined by the Polestar. Then, using two temporary sighting sticks of exactly the same height (so as to permit sighting clear above the edge of the board) set the pointer exactly pointing to the Pole-star; that is, the same angle as the latitude of the place, and fix it there immovably. Then remove the two sighting sticks. As a timepiece, this dial will be found roughly correct for that latitude. The angle of the pointer, or style, must be changed for each latitude.
Building a Log Cabin
(From Country Life in America. May, 1905 )
There are as many different kinds of log cabins as of any other architecture. It is best to begin with the simplest. The tools needed are a sharp ax, a crosscut saw, an inch auger, and a spade. It is possible to get along with nothing but an ax (many settlers had no other tool), but the spade, saw, and auger save much work.
For the site select a high, dry place, in or near the woods, and close to the drinking-water. It should be a sunny place, and with a view, preferably one facing south or east. Clear off and level the ground. Then bring your logs. These are more picturesque with the bark left on, but last longer peeled. Eight feet by twelve feet outside makes a good cabin for three or four boys.
Cut and carry about twelve logs, each ten feet long; and twelve more, each fourteen feet long. The logs should be at least six inches through. Soft wood is preferable, as it is easier to handle; the four ground logs or sills, at least, should be of cedar, chestnut, or other wood that does not rot. Lay two of the fourteen-foot logs on the ground, at the places for the long sides, and seven feet apart. Then across them, at the end, lay two short ones, eleven feet apart. This leaves about a foot projecting from each log. Roll the last two into their resting places, and flatten them till they sit firmly. It is of prime importance that each log rest immovably on the one below. Now cut the upper part of each end log, to an edge over each corner. (Fig. 1.)
{60}
Next put on two long logs, roll them onto the middle, taking care to change off, so the big end at a given comer may be followed next time by the small end and insure the corner rising evenly. Roll one of these large logs close to where it is to be placed, then cut on its upper surface at each end a notch corresponding with the ridge on the log it is to ride on. When ready, half a roll drops it into place. The log should be one to three inches above the one under it, and should not touch except at {61} the ends. Repeat the process now with the other sides, then the two ends, etc., always keeping the line of the corner plumb. As the walls rise, it will be found necessary to skid the larger logs; that is, roll them up on two long logs, or skids, leaning against the wall. (Fig. 2.)