Fig. 139. Sending a message with a cigar-box telegraph.
Experiment 76. Examine the cigar-box telegraph (see Appendix B) and notice that it is made on the same principle as was the magnetized bolt in Experiment 75. Complete the circuit through the electromagnet (the bolt wound with wire) by connecting the two ends of the wire that is wrapped around the bolt, with wires from the two poles of the battery. By making and breaking the circuit (connecting and disconnecting one of the wires) you should be able to make the lower bolt jump up and down and give the characteristic click of the telegraph instrument.
Fig. 140. Connecting up a real telegraph instrument.
In this experiment it does not matter how long the wires are if the batteries are strong enough. Of course it makes no difference where you break the circuit. So you could have the batteries in the laboratory and the cigar box a hundred miles away, with the wire going from the batteries to the bolt and back again. Then if you made and broke the circuit at the laboratory, the instrument would click a hundred miles away. If you want to, you may take the cigar-box telegraph out into the yard, leaving the batteries in the laboratory, while you try to telegraph this short distance.
Examine a regular telegraph instrument. Trace the wire from one binding post, around the coil and through the key, back to the other binding post, and notice how pushing down the key completes the circuit and how raising it up breaks the circuit.
Experiment 77. Connect two regular telegraph instruments, leaving one at each end of the long laboratory table. Make the connections as follows:
Take a wire long enough to go from one instrument to the other. Fasten the bare ends of this wire into the right-hand binding post of the instrument at your left, and into the left-hand binding post of the instrument at your right; that is, connect the binding posts that are nearest together, as in Figure 141.
Now connect one wire from the laboratory battery to the free post of the right-hand instrument. Connect the other wire from the laboratory battery to the ground through a faucet, radiator, or gas pipe, making the connection firm and being sure that there is a good, clear contact between the bare end of the wire and the metal to which the wire is attached.
