Diagrams of a Christmas Tree Stand.
Now cut from your packing box sixteen strips or pickets one and three-quarters inches wide and fourteen inches long, like Fig. 8. These may be “ripped out” with a saw and smoothed up with a plane and sandpaper.
Christmas Tree Stand.
To “assemble” the standard join first the two Fig. 6 strips and two Fig. 7. This leaves a hole two inches square in the center and two strips projecting from each of the four sides. Place the first square frame that you made on this, so that its sides will be equally distant from the center, and nail in position. Next nail the pickets in position so that the lower end of the pickets will be “flush” with the lower side of the frame. Next, hold the upper frame, with the grooves up, in position, eight inches above the lower frame and nail the pickets to that. Fig. 9 shows the complete assembly.
Now give the frame, and the two pieces like Fig. 5 a coat of dark green paint, and the standard is ready for use. Slip the tree into the square hole in the base. If the trunk is a bit too large, whittle it to fit. Then place the two pieces like Fig. 5 around the trunk at the top of the frame for a clamp, and slip them into the grooves in the upper frame, and you will find your tree quite ready to stand up and behave.