Fig. 5 shows the back or inside of the movable screen toward the part of the room used as the bedroom. On one side, and at the top and bottom, it has shelves with shelf-boxes, which are cheaper and better than drawers, and much preferred by those using them. Handles are cut in the front and back side, as seen in Fig. 6. Half an inch space must be between the box and the shelf over it, and as much each side, so that it can be taken out and put in easily. The central part of the screen's interior is a wardrobe.
[Image: Panel screens]
This screen must be so high as nearly to reach the ceiling, in order to prevent it from overturning. It is to fill the width of the room, except two feet on each side. A projecting cleat or strip, reaching nearly to the top of the screen, three inches wide, is to be screwed to the front sides, on which light frame doors are to be hung, covered with canvas and panel-paper like the front of the screen. The inside of these doors is furnished with hooks for clothing, for which the projection makes room. The whole screen is to be eighteen inches deep at the top and two feet deep at the base, giving a solid foundation. It is moved on four wooden rollers, one foot long and four inches in diameter. The pivots of the rollers and the parts where there is friction must be rubbed with hard soap, and then a child can move the whole easily.
A curtain is to be hung across the whole interior of the screen by rings, on a strong wire. The curtain should be in three parts, with lead or large nails in the hems to keep it in place. The wood-work must be put together with screws, as the screen is too large to pass through a, door.
[Illustration: Fig. 6.]
[Illustration: Fig. 7.]
[Illustration: Fig. 8.]
At the end of the room, behind the screen, are two couches, to be run one under the other, as in Fig. 7. The upper one is made with four posts, each three feet high and three inches square, set on casters two inches high. The frame is to be fourteen inches from the floor, seven feet long, two feet four inches wide, and three inches in thickness. At the head, and at the foot, is to be screwed a notched two-inch board, three inches wide, as in Fig. 8. The mortises are to be one inch wide and deep, and one inch apart, to revive slats made of ash, oak, or spruce, one inch square, placed lengthwise of the couch. The slats being small, and so near together, and running lengthwise, make a better spring frame than wire coils. If they warp, they can be turned. They must not be fastened at the ends, except by insertion in the notches. Across the posts, and of equal height with them, are to be screwed head and foot-boards.
The under couch is like the upper, except these dimensions: posts, nine inches high, including castors; frame, six feet two inches long, two feet four inches wide. The frame should be as near the floor as possible, resting on the casters.
[Illustration: Fig. 9.]
The most healthful and comfortable mattress is made by a case, open in the centre and fastened together with buttons, as in Fig. 9; to be filled with oat straw, which is softer than wheat or rye. This can be adjusted to the figure, and often renewed.
Fig. 10 represents the upper couch when covered, with the under couch put beneath it. The coverlid should match the curtain of the screen; and the pillows, by day, should have a case of the same.