Fig. 1.—Plan of Marionette stage.
CHAPTER XLI
HOW TO MAKE AND WORK MARIONETTES
Constructing the Stage
Marionettes, though claiming no rivalry to the time-honored institution of Punch and Judy, have a great charm of their own, and, with no traditional story of Punch, Judy, and Dog Toby, are at liberty to perform whatever play their manager may desire.
Although it is possible, of course, to purchase ready-made Marionette theaters and puppets, the purpose of this chapter is to describe a method by which the whole apparatus can be constructed at home at the cost of very little money and time.
Naturally, the first thing to be made is the stage. This must depend very much upon the Marionettes you intend to work. As a convenient size, suppose you decide upon figures 8 inches in height. This means that the frontage of the stage must be about 28 inches wide by 16 inches high, whilst it will run back to a depth of some 14 inches.
Make a base of plain wood, 42 inches by 22 inches. If more convenient this can be made in two pieces, each 21 inches by 22 inches. These fit together flush and are held by a couple of hooks and nails fastening beneath. Glue a block of wood at each corner to form a support, as shown in [Fig. 1], which depicts the under side of the base. A, B are the two hooks and nails; C, C, C, C are the above-mentioned blocks. At a distance of 2 inches from what will be the front, and 21⁄2 inches from either end, cut a mortice in each piece of the base (D, D in the figure), through which the tenons of the stage front will project. They must, therefore, be made to suit the thickness of the wood employed. At a distance of 5 inches from the back make four mortices, a couple in each part of the base as E, E, E, E in the figure. These will serve to hold the rear of the stage.
The front of the stage is now constructed as indicated by [Fig. 2]. Two pieces must be made exactly similar to one another, each to form one-half of the front. The tenon, D, should be long enough to pass through the mortice made for it in the base, and project from the other side sufficiently to allow of a peg being pushed through a hole bored in it. This peg will serve to maintain the upright front in place. Furthermore, two hooks must be placed upon one of the halves, to fasten to corresponding nails in the other half, thus holding the pieces of the stage front firmly together.