Block used in printing the peacock design
Preliminary Sketches and the Drawing.—It will be found desirable to make many preliminary sketches in charcoal or soft pencil, rubbing in a part of each sketch with a tone in order to secure immediately the dark and light effect. These should be compared, keeping clearly in mind the principles stated above. When one possessing the right qualifications has been found, the next step is to draw on a fresh piece of paper an accurate 3-inch square and copy upon it the satisfactory design in pencil outline. This should be done very carefully, that the spirit of the original charcoal sketch may not be lost. When the drawing is completed it must be put into shape to be transferred to the block. To do this we fasten a piece of rice-paper over the drawing and trace with very light pencil lines, filling in the dark spaces with black ink, using a brush. This brush work may be done directly without the pencil line if the drawing underneath shows very plainly through the paper. When the ink has thoroughly dried, the design may be cut out on the edge of the 3-inch square.
Bird pattern
Laying the Pattern and Cutting the Block.—A block 3 × 3 × 7⁄8 inches will now be required. This should be procured and sand-papered. One face of it should then be covered with a coating of library paste, the pattern laid upon it, and rubbed down smooth. If the design is symmetrical it should be pasted on the block, ink side up, but otherwise with the ink side down, or the design will be reversed upon the cloth. When the paste gets quite dry one may then fasten the block in the vise and, holding the blade of the knife at a slight angle and always away from the dark spots, proceed to cut the design along the outlines. These must be kept very smooth and sharp. All of the white shapes should be cut out, leaving the black ones in relief. Usually an eighth of an inch will be deep enough for the background, but it will be found after practise in printing that the larger spaces should be cut deeper and that, when the edges or corners of the block form a part of the background instead of the dark pattern, they also need a deeper cut. The paper that still adheres to the face of the block may now be removed by rubbing it upon a sheet of sand-paper laid upon something hard and smooth like glass in order that the block may have an absolutely level surface.
A flower and leaf design
Block used in printing this design
The Padded Board.—All block printing should be done upon a padded board. A very convenient one can be made by laying upon a bread board three or four sheets of blotting paper, and tacking over these several thicknesses of cheese cloth. In place of these an ironing board may be used.