Method of mortising
After the stock is well smoothed, the top and the shelves should be squared off, cut to length, and block planed. The posts should then be cut and accurately trimmed to dimensions. They may be marked with a knife line for the gains into which the corners of the shelves are to be fastened. Since the posts are perfectly square, no attention will have to be given to their exact location in marking or cutting the gains; but when the mortising for the rails is laid out, care must be exercised to mark them so that the mortises will come on the proper faces for assembling. In mortising for the top rail it is well not to work up to the end of the post but to cut back, say 3⁄4 of an inch, as shown in one of the details. The rails may now be laid off and the tenons cut and fitted. It is exactly 81⁄2 inches between the shoulders of the rails. Since the shelves are 101⁄2 inches wide, one inch is thus left on each side to be gained into the posts.
Method of fastening shelf
The parts are now ready for the first assembling. To do this it is convenient to have a clear bench top on which the posts may be laid on one side, face down. The rails and shelves may then be slipped into place, the other two posts placed on top, and the whole clamped firmly together. This is the preliminary assembling for the purpose of testing the accuracy of the work. If it be found all right, it should be taken apart again, and, after glue has been applied to the tenons and to the ends of the shelves, the parts should be quickly re-assembled and clamped up as before, with the angles kept true. Before the glue hardens the shelves should be nailed into the posts, as indicated in the drawing. In this case it is the nail that is the main stay. The glue is accessory, adding much to the stiffness of the construction.
Method of fastening posts to the top
The top may now be set on and fastened by screws or by brads driven through into the posts and well set so that they may be concealed by putty, coloured to match the stain used. The end slats should be fastened on in the same way. The back and ends of the closet are next cut to size and bradded in. The door is then fitted and, to break the surface a little, an ornamental design is cut in the centre. Still further relief is given by setting in the door 1⁄4 of an inch from the edge of the shelf and ends of the closet. The door is now hung on brass hinges, the stop and catch added, and the stand is ready for staining and finishing.