Book-Rack.—A simple rack for books (Fig. 280) can be of any length desired, about six inches wide, and of half-inch stock (or slightly thinner), but the dimensions can be varied according to circumstances.
Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in [Part V]., and look up any other references.
Be sure that the bottoms of the ends are accurately cut. The other edges can be rounded if you wish (see Spokeshave and File). The hinges should be sunk in the wood, so that they will not injure the books (see Hinges).
See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in [Part V].
Desk-Rack.—An easily made arrangement to put on the back of a table or desk is shown in Fig. 281, and can be made of stock of from ½" to 7/8" thickness, according to the size of the rack.
Fig. 281.
Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in [Part V]., and look up any other references.
