See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in [Part V].
Plant-Stands.—The form shown in Fig. 308 is of quite simple construction and is useful to hold a large flower-pot. It should be made of 7/8" stock. The top can be from 8" to 12" square.
Fig. 308.
Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in [Part V]., and look up any other references.
Simply make a box (see Box-making, page 219), without top and bottom, with the grain of the four sides running up and down. Before putting together saw the curves at the bottom. As the grain of the four pieces all runs up and down, these sides can be glued together without nailing (see Gluing). Screw four cleats around the inside of the top (Fig. 309) with holes bored in them for screws with which to fasten on the top from underneath (see Boring and Screws). Round the top edge as shown (see Spokeshave and File), and smooth the surfaces. Then, having shaped the edge of the top as shown in Fig. 308, fasten it in place and the stand is ready to finish.
Fig. 309.
See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in [Part V].