Fig. 317a.
The remaining details do not differ from those in the preceding cases.
See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in [Part V].
Small Stand.—A simple arrangement shown in Fig. 318 involves more difficulties than many of the other articles shown, but is not beyond the skill of the careful amateur. A good size is about 13" or 14" across the top and 17" or 18" high. Such a stand is useful to hold a flower-pot.
Fig. 318.
Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in [Part V]. and look up any other references.
The top can be of ½" or 5/8" stock and the legs of 7/8" stock, the lower part tapering in thickness to 5/8" at the bottom. The curves can all be sawed at a mill for a small sum, and smoothed with spoke-shave and file (see Spokeshave and File). The underside of the top can be bevelled at the edge (Fig. 319). This can be done with the spoke-shave. The file can be used to good advantage in the rounding of the extreme edge, finishing with sandpaper, but not until after the top surface has been finally smoothed (see Spokeshave, File, and Sandpaper).