Winding from Cops.
The object of the machine shown on [Fig. 7] is to wind the yarn from the cop to a bobbin of about 4-1/2 inches lift—that is, having a barrel 1-1/2 inches diameter, and a head or flange at each end with a space between of 4-1/2 inches.
The machine, [Fig. 7], is duplex, having similar parts on each side of the frame; on each side will be observed two rows of spindles driven from a central tin drum by bands; five inches from the top of the spindle is fixed a braid bearing a flannel washer on which the bobbins rest, and are driven round by the friction; the cops are fixed in a spindle rail, the end from each passing round a knee board covered with flannel, thence through a brush which serves a secondary object of cleansing the thread from loose dirt, and tightening it so as to prevent snicks being formed. In front of this brush is fixed a guide plate, slitted to prevent the winder lifting the thread so as to pass lumps too large to go through the slits.
FIG. 7.—WINDING MACHINE. To face pp. 22 and 23.
The brush and guide plate form a traverse, moving in slides alternately up and down to fill the bobbin with yarn, which is drawn from the cop through these “cleaners” by the friction between the bobbin and the revolving spindle. To enable a greater length of yarn to be wound on the bobbin, it is made of a barrel shape—i.e., of greater diameter at the middle than at the ends. Although the first few layers appear parallel, a greater increase of diameter is noticed at the centre of the lift afterwards, simply caused by allowing a longer dwell of the traverse than at the ends of the bobbin.
