[Transcriber's Note: To see a larger version of this image, click [here].]

To Soften the Bark

Next the bark is unrolled. If it has laid until it has become a little hardened, it is placed in the river or stream for a day or two. It is spread out flat, and laid upon the bed with the gray or outside surface up. The inside surface is placed downward, and becomes the outside of the canoe.

The frame is replaced upon the bark, so that it will be at the same distance from each side and end of the bed that it was before. At each cross-bar boards are laid across the frame, and heavy stones are laid upon them to keep the frame solid and immovable upon the bark ([Fig. 85], C). The edges of the bark are next bent up in a perpendicular position, and in order that it may bend smoothly slits are made in the bark in an outward direction, at right angles to the frame. A cut is made close to the end of each cross-bar, and one half way between each bar, which is generally sufficient to allow the bark to be bent up smoothly. As the bark is bent up, the large stakes are slipped back in the holes which they occupied before, and the tops of each opposite pair are connected with a strip of cedar bark which keeps the stakes perfectly perpendicular. At each end it is necessary to take out a small triangular piece or gore, so that the edges may come together without overlapping.

Next twenty-two pieces of cedar, one to two feet long, and about ½ or ¾ inch thick, are split out, and whittled thin and flat at one end. This sharpened edge is inserted between the outside edge of the frame and the bent-up bark, opposite each large stake. The other end of the chisel-shaped piece is tightly tied to the large stake outside. By means of the large outside stake and the inside "stake," so-called, the bark is held in a perfectly upright position; and in order to keep the bent-up part more perfectly flat and smooth, the strips of cedar are pushed in lengthwise between the stakes and the bark, on each side of the bark, as shown in sectional views ([Fig. 85], C, D).

Sometimes, in place of having temporary strips to go on outside of the bark, the long outside strip (B, [Fig. 83]), is slipped in place instead.

It may now be seen if the bark is not wide enough. If it is not, the sides must be pieced out with a narrow piece, cut in such a way that the eyes in the bark will run in the same direction as those of the large piece.

As a general rule, from the middle to the next bar the strip for piecing is placed on the inside of the large piece, whose upper edge has previously been trimmed straight, and the two are sewed together by the stitch shown in [Fig. 86], the spruce root being passed over another root laid along the trimmed-off edge of the large piece of bark to prevent the stitches from tearing out. From the second bar to the end of the canoe, or as far as may be necessary, the strip is placed outside the large piece, and from the second to the end bar is sewed as in [Fig. 87], and from the end bar to the end of the canoe is stitched as in [Fig. 88].

Next, the weights are taken off the frame, which is raised up as follows, the bark remaining flat on the bed as before:

A post eight inches long is set up under each end of middle cross-bar ([Fig. 85], D), one end resting on the bark and the other end supporting either end of the middle cross-bar. Another post, nine inches long, is similarly placed under each end of the next cross-bar. Another, twelve inches long, is placed under each end of the end cross-bar; and another, sixteen and a half or seventeen inches, supports each end of the frame.