Antenna Lead—
Attach the black antenna lead to the car antenna and plug the connector on the antenna lead into the receiver chassis as shown in the Installation Diagrams. Ground the pigtail of the antenna lead shield to a convenient body bolt. Keep antenna lead out of engine compartment to avoid possibility of ignition interference being picked up by the lead-in.
Speaker—
See Instructions in speaker package.
Remote Control Unit—
See Instructions in remote control package.
CONTROL UNIT ADJUSTMENT
The volume control and station selector shafts are AUTOMATICALLY adjusted as follows:
1. Insert control cables in their respective bushings on the case (volume control is upper bushing when receiver is installed in the car), until they seat themselves and then tighten the set screws.
2. Turn the station selector knob to the right (clockwise) until it stops—then turn the knob counter-clockwise until it stops. The dial is now logged.