OPERATION
To Turn On Receiver—
Some control units have a small knob located below the center of the dial. If your receiver is equipped with this type of control push this small knob in as far as it will go. Other control units have a combination on-off switch and volume control knob. To turn on this type of control turn the knob clockwise until the switch clicks and the dial is illuminated.
Volume Control—
Turning the volume control knob toward the right increases the output of the receiver and turning it toward the left reduces the output.
How To Tune The Receiver—
Turn the volume control knob approximately half way to the right. Rotate the station selector knob slowly until a station is heard. Tune this station in until the minimum amount of background noise is heard. Increase or decrease the volume to the desired level by adjusting the volume control knob. Careful tuning will result in better tone quality from all stations.
If the program being received is from a powerful local station local interference may be practically eliminated by turning the sensitivity control to the LOCAL position. You then will get the best possible reproduction of that station's program.
