As phosphorus melts at about 40°, it condenses at the bottom of the receiver in a molten liquid mass, which is cast under water in tubes, and is sold in the form of sticks. This is common or yellow phosphorus. It is a transparent, yellowish, waxy substance, which is not brittle, almost insoluble in water, and easily undergoes change in its external appearance and properties under the action of light, heat, and of various substances. It crystallises (by sublimation or from its solution in carbon bisulphide) in the regular system, and[2] (in contradistinction to the other varieties) is easily soluble in carbon bisulphide, and also partially in other oily liquids. In this it recalls common sulphur. Its specific gravity is 1·84. It fuses at 44°, and passes into vapour at 290°; it is easily inflammable, and must therefore be handled with great caution; careless rubbing is enough to cause phosphorus to ignite. Its application in the manufacture of matches is based on this.[2 bis] It emits light in the air owing to its slow[3] oxidation, and is therefore kept under water (such water is phosphorescent in the dark, like phosphorus itself). It is also very easily oxidised by various oxidising agents and takes up the oxygen from many substances.[3 bis] Phosphorus enters into direct combination with many metals and with sulphur, chlorine, &c., with development of a considerable amount of heat. It is very poisonous although not soluble in water.
Besides this, there is a red variety of phosphorus, which differs considerably from the above. Red phosphorus (sometimes wrongly called amorphous phosphorus) is partially formed when ordinary phosphorus remains exposed to the action of light for a long time. It is also formed in many reactions; for example, when ordinary phosphorus combines with chlorine, bromine, iodine, or oxygen, a portion of it is converted into red phosphorus. Schrötter, in Vienna, investigated this variety of phosphorus, and pointed out by what methods it may be produced in considerable quantities. Red phosphorus is a powdery red-brown opaque substance of specific gravity 2·14. It does not combine so energetically with oxygen and other substances as yellow phosphorus, and evolves less heat in combining with them.[4] Common phosphorus easily oxidises in the air; red phosphorus does not oxidise at all at the ordinary temperature; hence it does not phosphoresce in the air, and may be very conveniently kept in the form of powder. It does not, like yellow phosphorus, fuse at 44°. After being converted into vapour at 290° or 300°, it again passes into the ordinary variety when slowly cooled. Red phosphorus is not soluble in carbon bisulphide and other oily liquids, which permits of its being freed from any admixture of the ordinary phosphorus. It is not poisonous, and is used in many cases for which the ordinary phosphorus is unsuitable or dangerous; for example, in the manufacture of matches, which are then not poisonous or inflammable by accidental friction, and therefore the red variety has now replaced the ordinary phosphorus.[4 bis]
The heads of the ‘safety’ matches do not contain any phosphorus, but only substances capable of burning and of supporting combustion. Red phosphorus is spread over a surface on the box, and it is the friction against this phosphorus which ignites the matches. There is no danger of the matches taking fire accidentally, nor are they poisonous.[5] This red phosphorus is prepared by heating the ordinary phosphorus at 230° to 270°; it is evident that this must be done in an atmosphere incapable of supporting combustion—for example, in nitrogen, carbonic anhydride, steam, &c. On a large scale, ordinary phosphorus is placed in closed iron vessels,[5 bis] and immersed in a bath of different proportions of tin and lead, by which means the temperature of 250° necessary for the conversion is easily attained. It is kept at this temperature for some time. The temperature is at first cautiously raised, and the air is thus partially expelled by the heat, and also by the evolution of steam (the phosphorus is damp when put in), whilst the remaining oxygen is also partially absorbed by the phosphorus, so that an atmosphere of nitrogen is produced in the iron vessel. Red phosphorus enters into all the reactions proper to yellow phosphorus, only with greater difficulty and more slowly;[6] and, as its vapour tension (volatility) is less than that of the yellow variety, it may be supposed that a polymerisation takes place in the passage of the yellow into the red modification, just as in the passage of cyanogen into paracyanogen, or of cyanic acid into cyanuric acid (Chapter IX. Notes [39 bis] and [48]).
The vapour of phosphorus is colourless; its density remains constant between 300° and 1000° (Dumas, 1833; Mitscherlich, Deville, and Troost, 1859, and others). The density with respect to air has been determined as from 4·3 to 4·5. Hence, referred to hydrogen, it is 4·4 × 14·4 = 63, corresponding with a molecular weight 124, i.e. the molecule of phosphorus in a state of vapour contains P4. The reader will remember that the molecule of nitrogen contains N2, of sulphur S6 or S2, and of oxygen O2 or O3.
The chemical energy of phosphorus in a free state more nearly approaches that of sulphur than nitrogen. Phosphorus is combustible and inflames at 60°; but having in the act of combination parted with a portion of its energy in the form of heat it becomes analogous to nitrogen, so long as there is no question of its reduction back again into phosphorus. Nitric acid is easily reduced to nitrogen, whilst phosphoric acid is reduced with very much greater difficulty. All the compounds of phosphorus are less volatile than those of nitrogen. Nitric acid, HNO3, is easily distilled; metaphosphoric acid, HPO3, is generally said to be non-volatile; triethylamine, N(C2H5)3, boils at 90°, and triethylphosphine, P(C2H5)3, at 127°.
Phosphorus not only combines easily and directly with oxygen, but also with chlorine, bromine, iodine, sulphur, and with certain metals, and red phosphorus when heated combines with hydrogen also.[6 bis] So, for instance, when fused with sodium under naphtha, phosphorus gives the compound Na3P2. Zinc, absorbing the vapour of phosphorus, gives the phosphide Zn3P2 (sp. gr. 4·76); tin, SnP; copper, Cu2P; even platinum combines with phosphorus (PtP2, sp. gr. 8·77).[6 tri] Iron, when combined even with a small quantity of phosphorus, becomes brittle.[7] Some of these compounds of phosphorus are obtained by the action of phosphorus on the solutions of metallic salts, and by the ignition of metallic oxides in the vapour of phosphorus, or by heating mixtures of phosphates with charcoal and metals. Phosphides do not exhibit the external properties of salts, which are so clearly seen in the chlorides and still distinctly observable in the sulphides. The phosphides of the metals of the alkalis and of the alkaline earths are even immediately and very easily decomposed by water, whereas this is found to be the case with only a very few sulphides, and still more rarely and indistinctly with the chlorides. We may take calcium phosphide as an example.[7 bis] Phosphorus is laid in a deep crucible, and covered with a clay plug, over which lime is strewn. At a red heat the vapours of phosphorus combine with the oxygen of the lime and form phosphoric anhydride, which forms a salt with another portion of the lime, whilst the liberated calcium combines with the phosphorus and forms calcium phosphide. Its composition is not quite certain; it may be CaP (corresponding with liquid phosphuretted hydrogen). This substance is remarkable for the following reaction: if we take water—or, better still, a dilute solution of hydrochloric acid—and throw calcium phosphide into it, bubbles of gas are evolved, which take fire spontaneously in the air and form white rings. This is owing to the fact that the liquid hydrogen phosphide, PH2, is first formed, thus, CaP + 2HCl = CaCl2 + PH2, which, owing to its instability, very easily splits up into the solid phosphide, P2H, and gaseous phosphide, PH3; 5PH2 = P2H + 3PH3; the latter corresponds with ammonia. The mixture of the gaseous and liquid phosphides takes fire spontaneously in the air, forming phosphoric acid. The same hydrogen phosphides are formed when water acts on sodium phosphide (P2Na3). A similar mixture of gaseous liquid and solid phosphuretted hydrogen (Retgers 1894) is formed by heating (in a glass tube) red phosphorus in a stream of dry hydrogen. Hence we see that there are three compounds of phosphorus with hydrogen. (1) The first or solid yellow phosphide, P2H (more probably P4H2), is obtained by the action of strong hydrochloric acid on sodium phosphide; it takes fire when struck or at 175°. (2) The liquid, PH2, or more correctly expressed as the molecule, P2H4, is a colourless liquid which takes fire spontaneously in the air, boils at 30°, is very unstable, and is easily decomposed (by light or hydrochloric acid) into the two other phosphides of hydrogen. It is prepared by passing the gases evolved by the action of water on calcium phosphide through a freezing mixture.[8] And, lastly, (3), gaseous hydrogen phosphide, phosphine, PH3, which is distinguished as being the most stable. It is a colourless gas, which does not take fire in the air. It has an odour of garlic, and is very poisonous. It resembles ammonia in many of its properties.[8 bis] It is easily decomposed by heat, like ammonia, forming phosphorus and hydrogen; but it is very slightly soluble in water, and does not saturate acids, although it forms compounds with some of them which resemble ammonium salts in their form and properties. Among them the compound with hydriodic acid, PH4I, analogous to ammonium iodide, is remarkable. This compound crystallises on sublimation in well-formed cubes, like sal-ammoniac, which it resembles in many respects. However, this compound does not enter into those reactions of double decomposition which are proper to sal-ammoniac, because its saline properties are very feebly developed. Phosphuretted hydrogen also combines, like ammonia, with certain chloranhydrides; but they are decomposed by water, with the evolution of phosphine. Ogier (1880) showed that hydrochloric acid also combines with phosphine under a pressure of 20 atmospheres at +18°, and under the ordinary pressure at -35°, forming the crystalline phosphonium chloride PH4Cl, corresponding to sal-ammoniac. Hydrobromic acid does the same with greater ease, and hydriodic acid with still greater facility, forming phosphonium iodide, PH4I.[9]
Phosphuretted hydrogen, or phosphine, PH3, is generally prepared by the action of caustic potash on phosphorus.[10] Small pieces of phosphorus are dropped into a flask containing a strong solution of caustic potash and heated. Potassium hypophosphite, H2KPO2, is then obtained in solution; gaseous phosphuretted hydrogen is evolved:
P4 + 3KHO + 3H2O = 3(KH2PO2) + PH3.
Liquid phosphuretted hydrogen (and free hydrogen) is also formed, together with the phosphine, so that the gaseous product, on escaping from the water into the air, takes fire spontaneously, forming beautiful white rings of phosphoric acid. In this experiment, as in that with calcium phosphide, it is the liquid, P2H4, that takes fire; but the phosphine set light to by it also burns, PH3 + O4 = PH3O4. The same phosphuretted hydrogen, PH3, may be obtained pure, and not spontaneously combustible, by igniting the hydrates of phosphorous acid (4PH3O3 = PH3 + 3PH3O4) and hypophosphorous acid (2PH3O2 = PH3 + PH3O4); or, more simply, by the decomposition of calcium phosphide by hydrochloric acid, because then all the liquid phosphide, P2H4, is decomposed into non-volatile P2H and gaseous PH3. Pure phosphine liquefies when cooled to -90°, boils at -85°, and solidifies at -135° (Olszewski). When phosphorus burns in an excess[10 bis] of dry oxygen, then only phosphoric anhydride, P2O5 is formed. It is prepared by dropping pieces of phosphorus through a wide tube, fixed into the upper neck of a large glass globe, on to a cup suspended in the centre of the globe. These lumps are set alight by touching them with a hot wire, and the phosphorus burns into P2O5. The dry air necessary for its combustion is forced into the globe through a lateral neck, and the white flakes of phosphoric anhydride formed are carried by the current of air through a second lateral neck into a series of Woulfe's bottles, where they settle as friable white flakes. Phosphoric anhydride may also be formed by passing dry air through a solution of phosphorus in carbon bisulphide. All the materials for the preparation of this substance must be carefully dried, because it combines with great eagerness with water, at the same time developing a large amount of heat and forming metaphosphoric acid, HPO3, from which the water cannot be separated by heat. Phosphoric anhydride is a colourless snow-like substance, which attracts moisture from the air with the utmost avidity. It fuses at a red heat, and then volatilises. Its affinity for water is so great that it takes it up from many substances. Thus it converts sulphuric acid into sulphuric anhydride, and carbohydrates (wood, paper) are carbonised, and give up the elements of water when brought into contact with it.