Take a sheet of stiffish paper about the size of this page and fold it longways, exactly double. Then fold the corners of one end back to the main fold, one each side. The paper sideways will then look as in Fig. 1. Then double these folded points, one each side, back to the main fold. The paper will then look as in Fig. 2. Repeat this process once more. The paper will then look as in Fig. 3. Compress the folds very tightly, and open out the top ones, so that in looking down on the dart it will have the appearance of Fig. 4. The dart is then ready for use.
Paper Mats
Paper Mats
Take a square piece of thin paper (Fig. 1), white or colored. Fold it in half (Fig. 2), and then again in half (Fig. 3), and then again from the centre to the outside corner, when it will be shaped as in Fig. 4. If you want a round mat, cut it as marked by the dotted line in Fig. 4; if square, leave it as it is. Remember that when you cut folded paper the cuts are repeated in the whole piece as many times as there are folds in the paper. The purpose of folding is to make the cuts symmetrical. Bearing this in mind cut Fig. 4 as much as you like, as suggested by Fig. 5. Perhaps it would be well to practice first of all on a rough piece. The more delicate the cuts the prettier will be the completed mat.
Paper Boxes
Paper Boxes
Take an exactly square piece of paper (cream-laid note-paper is best in texture), and fold it across to each corner and press down the folds. Unfold it and then fold each corner exactly into the middle, and press down and unfold again. The lines of fold on the paper will now be seen to run from corner to corner, crossing in the middle, and also forming a square pattern. The next thing is to fold over each corner exactly to the line of this square on the opposite half of the paper. When this is done, and the paper is again straightened out, the lines of fold will be as in Fig. 1. Cut out the triangles marked X in Fig. 1, and the paper will be as in Fig. 2. Then cut along all the dotted lines in Fig. 2, and stand the opposite corners up to form the sides and lid of the box: first A and B, which are fastened by folding back the little flaps at the tip of A, slipping through the slit at the tip of B, and then unfolding them again; and then C and D, which are secured in the same way.