It might be added that cardboard figures can be made to stand up either by leaving a strip of cardboard at the bottom, in which teeth can be cut and bent alternately one way or the other, or by slipping the feet into grooves cut in little blocks of wood.
Cardboard Cut-Outs
There are a great many cut-outs issued nowadays, which may be bought for a small sum at any toy shop. Perhaps the best among these are "The Mirthful Menagerie," "The Agile Acrobats" and "The Magic Changelings." "The Mirthful Menagerie" when properly cut out and pasted together, make a lot of animals that have thickness as well as length and height; "The Agile Acrobats" can be made to assume almost any position, and in "The Magic Changelings," Little Red Riding Hood, for instance, can be changed into the wolf, and then back again!
Books of cut-outs are also made, in which the books are intact after the cut-outs have been removed. "The New Mother Goose" gives illustrations of many of the Mother Goose rhymes to be cut out and pasted together, and has a story and other pictures besides. "The Electric Fire Fighters" is on the same order, only in this case the pictures to be put together are of the Electric Fire-Engine, the Electric Water-Tower, etc. They are all easily made, and are fascinating games for stormy weather, or for indoor games at any time.
Particulars of "Snap" cards and other home-made cards will be found on pp. [77] and [78].
Kites
In China, and to some extent in Holland, kite-flying is not the pastime only of boys, but of grave men. And certainly grave men might do many more foolish things. To feel a kite pulling at your hands, to let out string and see it climb higher and higher and higher into the sky—this is a real joy. For good kite-flying you want plenty of room and a steady wind; hence a big field is the best place, unless you are at the seaside when there is a wind off the land, in which case you can fly your kite from the beach. To make an ordinary, serviceable kite, take two laths (which can be bought for a penny from any builder), one three feet long (AA in the picture) and the other two feet (BB). Screw BB with two screws exactly in the middle, at right angles to AA, at C, a foot from the top. Then take some stout twine of good quality and make the outline of the kite by tying it securely to the ends of each of the laths. Next take the thinnest unbleached calico you can find, stretch it fairly tightly, and sew it over the strings. (Or strong but light paper will do, pasted over the string.) Make a hole (D) through the upright lath and calico, midway between the cross-piece and the top, and another hole (E) about fifteen inches below the cross-piece, and tie a strong string, two and a half feet long, to these holes, with a loop (F) in it a foot from the top hole. To this loop you will tie the string of the kite. The tail (G) is made of pieces of paper about six inches long, rolled tightly and tied at distances of a foot. Its exact length will depend on the strength of the wind and can be determined only by experience, but, roughly speaking, it should be five times the height of the kite, or, with the kite which we are making, fifteen feet long. It is best to have the tail in two or three pieces, and then it can be lengthened or shortened at will. For instance, if the kite plunges in the air and will not keep steady, the tail is not long enough; but if it will go up only a little way, the tail is probably too long. Be sure to have plenty of string, carefully wound, so that there will be no hitches in paying it out. When starting a kite you need the help of some one who will stand about thirty yards away, holding the kite against the wind, and throw it straight up when you have the line tight and give the signal. If it does not rise it may be well for you to run a few yards against the wind. At first you must not pay out line very rapidly, but when the kite is flying steadily you may give it, also steadily, all the string it wants.
A Kite